@@ -124,7 +124,6 @@ static u32 sun4i_timer_sched_read(void)
static void __init sun4i_timer_init(struct device_node *node)
{
- unsigned long rate = 0;
struct clk *clk;
int ret, irq;
u32 val;
@@ -142,9 +141,7 @@ static void __init sun4i_timer_init(struct device_node *node)
panic("Can't get timer clock");
clk_prepare_enable(clk);
- rate = clk_get_rate(clk);
-
- writel(rate / (TIMER_SCAL * HZ),
+ writel(clk_get_rate(clk) / HZ,
timer_base + TIMER_INTVAL_REG(0));
/* set clock source to HOSC, 16 pre-division */
@@ -168,8 +165,8 @@ static void __init sun4i_timer_init(struct device_node *node)
sun4i_clockevent.cpumask = cpumask_of(0);
- clockevents_config_and_register(&sun4i_clockevent, rate / TIMER_SCAL,
- 0x1, 0xff);
+ clockevents_config_and_register(&sun4i_clockevent, clk_get_rate(clk),
+ 0x1, 0xffffffff);
writel(~0, timer_base + TIMER_INTVAL_REG(1));
writel(TIMER_CTL_ENABLE | TIMER_CTL_AUTORELOAD | TIMER_CTL_CLK_SRC(TIMER_CTL_CLK_SRC_OSC24M),
The prescaler is only used when using the internal low frequency oscillator (at 32kHz). Since we're using the higher frequency oscillator at 24MHz, we can just remove it. Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com> --- drivers/clocksource/sun4i_timer.c | 9 +++------ 1 file changed, 3 insertions(+), 6 deletions(-)