@@ -26,6 +26,7 @@
#include <linux/pm_runtime.h>
#include <linux/delay.h>
#include <linux/usb/omap_control_usb.h>
+#include <linux/of_platform.h>
#define PLL_STATUS 0x00000004
#define PLL_GO 0x00000008
@@ -198,6 +199,12 @@ static int omap_usb3_probe(struct platform_device *pdev)
{
struct omap_usb *phy;
struct resource *res;
+ struct device_node *node = pdev->dev.of_node;
+ struct device_node *control_node;
+ struct platform_device *control_pdev;
+
+ if (!node)
+ return -EINVAL;
phy = devm_kzalloc(&pdev->dev, sizeof(*phy), GFP_KERNEL);
if (!phy) {
@@ -239,11 +246,18 @@ static int omap_usb3_probe(struct platform_device *pdev)
return -EINVAL;
}
- phy->control_dev = omap_get_control_dev();
- if (IS_ERR(phy->control_dev)) {
- dev_dbg(&pdev->dev, "Failed to get control device\n");
- return -ENODEV;
+ control_node = of_parse_phandle(node, "ctrl-module", 0);
+ if (!control_node) {
+ dev_err(&pdev->dev, "Failed to get control device phandle\n");
+ return -EINVAL;
}
+ control_pdev = of_find_device_by_node(control_node);
+ if (!control_pdev) {
+ dev_err(&pdev->dev, "Failed to get control device\n");
+ return -EINVAL;
+ }
+
+ phy->control_dev = &control_pdev->dev;
omap_control_usb_phy_power(phy->control_dev, 0);
usb_add_phy_dev(&phy->phy);
omap_get_control_dev() is being deprecated as it doesn't support multiple instances. As control device is present only from OMAP4 onwards which supports DT only, we use phandles to get the reference to the control device. As we don't support non-DT boot, we just bail out on probe if device node is not present. Signed-off-by: Roger Quadros <rogerq@ti.com> --- drivers/usb/phy/phy-omap-usb3.c | 22 ++++++++++++++++++---- 1 files changed, 18 insertions(+), 4 deletions(-)