[RFC,4/9] of: mtd: add NAND timings bindings documentation

Commit Message

Boris BREZILLON Jan. 8, 2014, 2:21 p.m. UTC

Add a NAND timing properties to NAND dt doc.

Signed-off-by: Boris BREZILLON <[e-mail]>
---
 Documentation/devicetree/bindings/mtd/nand.txt |   34 ++++++++++++++++++++++++
 1 file changed, 34 insertions(+)

Patch

diff --git a/Documentation/devicetree/bindings/mtd/nand.txt b/Documentation/devicetree/bindings/mtd/nand.txt
index 03855c8..0dff600 100644
--- a/Documentation/devicetree/bindings/mtd/nand.txt
+++ b/Documentation/devicetree/bindings/mtd/nand.txt
@@ -5,3 +5,37 @@ 
   "soft_bch".
 - nand-bus-width : 8 or 16 bus width if not present 8
 - nand-on-flash-bbt: boolean to enable on flash bbt option if not present false
+
+nand timings definition expressed in nanoseconds (found in NAND datasheets):
+ - tCLS-min : CLE setup time
+ - tCLH-min : CLE Hold time
+ - tCS-min : CE# setup time
+ - tCH-min : CE# hold time
+ - tWP-min : WE# pulse width
+ - tALS-min : ALE setup time
+ - tALH-min : ALE hold time
+ - tDS-min : Data setup time
+ - tDH-min : Data hold time
+ - tWC-min : Write cycle time
+ - tWH-min : WE# high hold time
+ - tR-max : Data transfer from cell to register
+ - tAR-min : ALE to RE# delay
+ - tCLR-min : CLE to RE# delay
+ - tRR-min : Ready to RE# low
+ - tRP-min : RE# pulse width
+ - tWB-max : WE# high to busy
+ - tRC-min : Read cycle time
+ - tREA-max : RE# access time
+ - tRHZ-max : RE# high to output high Z
+ - tCHZ-max : CE# high to output high Z
+ - tRHOH-min : RE# high to output hold
+ - tRLOH-min : RE# low to output hold
+ - tCOH-min : RE# or CE# high to output hold
+ - tREH-min : RE# high hold time
+ - tWHR-min : WE# high to RE# low
+ - tRHW-min : RE# high to WE# low
+ - tIR-min : Output high Z to RE# low
+ - tCR-min : CE# low to RE# low
+ - tADL-min : Address to data loading time
+ - tRST-max : Device resetting time
+ - tWW-min : Write protection time