diff mbox

[v2,2/4] arm: mxs: dt: imx28-duckbill: fix phy reset gpio

Message ID 1395960690-19531-3-git-send-email-mhei@heimpold.de (mailing list archive)
State New, archived
Headers show

Commit Message

Michael Heimpold March 27, 2014, 10:51 p.m. UTC 
Fix a copy & paste error: on duckbills the GPIO used for resetting
the ethernet phy differs from FSL's MX28EVK board.

Reported-by: Stefan Wahren <info@lategoodbye.de>
Signed-off-by: Michael Heimpold <mhei@heimpold.de>
---
Changes since v1:
- none

 arch/arm/boot/dts/imx28-duckbill.dts |    4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)
diff mbox

Patch

diff --git a/arch/arm/boot/dts/imx28-duckbill.dts b/arch/arm/boot/dts/imx28-duckbill.dts
index a697870..91c1a9a 100644
--- a/arch/arm/boot/dts/imx28-duckbill.dts
+++ b/arch/arm/boot/dts/imx28-duckbill.dts
@@ -39,7 +39,7 @@ 
 				hog_pins_a: hog@0 {
 					reg = <0>;
 					fsl,pinmux-ids = <
-						MX28_PAD_ENET0_RX_CLK__GPIO_4_13 /* PHY Reset */
+						MX28_PAD_SSP0_DATA7__GPIO_2_7 /* PHY Reset */
 					>;
 					fsl,drive-strength = <MXS_DRIVE_4mA>;
 					fsl,voltage = <MXS_VOLTAGE_HIGH>;
@@ -82,7 +82,7 @@ 
 			pinctrl-names = "default";
 			pinctrl-0 = <&mac0_pins_a>;
 			phy-supply = <&reg_3p3v>;
-			phy-reset-gpios = <&gpio4 13 0>;
+			phy-reset-gpios = <&gpio2 7 GPIO_ACTIVE_LOW>;
 			phy-reset-duration = <100>;
 			status = "okay";
 		};