@@ -21,8 +21,6 @@
#include <mach/board-pb11mp.h>
#include <mach/board-pbx.h>
-#include <plat/platsmp.h>
-
#include "core.h"
static void __iomem *scu_base_addr(void)
@@ -71,15 +69,15 @@ static void __init realview_smp_prepare_cpus(unsigned int max_cpus)
* until it receives a soft interrupt, and then the
* secondary CPU branches to this address.
*/
- __raw_writel(virt_to_phys(versatile_secondary_startup),
+ __raw_writel(virt_to_phys(secondary_holding_pen),
__io_address(REALVIEW_SYS_FLAGSSET));
}
struct smp_operations realview_smp_ops __initdata = {
.smp_init_cpus = realview_smp_init_cpus,
.smp_prepare_cpus = realview_smp_prepare_cpus,
- .smp_secondary_init = versatile_secondary_init,
- .smp_boot_secondary = versatile_boot_secondary,
+ .smp_secondary_init = smp_secondary_init,
+ .smp_boot_secondary = smp_boot_secondary,
#ifdef CONFIG_HOTPLUG_CPU
.cpu_die = realview_cpu_die,
#endif
This is the first of three patches involved replacing the use of smp operations defined under arch/arm/mach-versatile. Both realview and vexpress use the same smp_boot_secondary and smp_secondary_init functions, and those are equivalent to the common ones now available in arch/arm/kernel/smp.c. We can't get rid of the mach-versatile functions yet, so this patch just switches mach-realview to use the common routines. Signed-off-by: Alex Elder <elder@linaro.org> --- arch/arm/mach-realview/platsmp.c | 8 +++----- 1 file changed, 3 insertions(+), 5 deletions(-)