diff mbox

[V3,11/19] mmc: mmci: Mark the DT bindings for highspeed mode as deprecated

Message ID 1397132462-8005-12-git-send-email-ulf.hansson@linaro.org (mailing list archive)
State New, archived
Headers show

Commit Message

Ulf Hansson April 10, 2014, 12:20 p.m. UTC 
The common mmc DT parser supports bindings for highspeed mode, thus
there are no need for mmci to provide it's own versions for these. Mark
them as deprecated in the documentation.

Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Acked-by: Rob Herring <robh@kernel.org>
---
 Documentation/devicetree/bindings/mmc/mmci.txt |   10 ++++++----
 1 file changed, 6 insertions(+), 4 deletions(-)
diff mbox

Patch

diff --git a/Documentation/devicetree/bindings/mmc/mmci.txt b/Documentation/devicetree/bindings/mmc/mmci.txt
index 2c8756f..03796cf 100644
--- a/Documentation/devicetree/bindings/mmc/mmci.txt
+++ b/Documentation/devicetree/bindings/mmc/mmci.txt
@@ -15,8 +15,6 @@  Required properties:
 Optional properties:
 - arm,primecell-periphid : contains the PrimeCell Peripheral ID, it overrides
                            the ID provided by the HW
-- mmc-cap-mmc-highspeed  : indicates whether MMC is high speed capable.
-- mmc-cap-sd-highspeed   : indicates whether SD is high speed capable.
 - vqmmc-supply           : phandle to the regulator device tree node, mentioned
                            as the VCCQ/VDD_IO supply in the eMMC/SD specs.
 - st,sig-dir-dat0        : bus signal direction pin used for DAT[0].
@@ -26,6 +24,10 @@  Optional properties:
 - st,sig-dir-cmd         : cmd signal direction pin used for CMD.
 - st,sig-pin-fbclk       : feedback clock signal pin used.
 
+Deprecated properties:
+- mmc-cap-mmc-highspeed  : indicates whether MMC is high speed capable.
+- mmc-cap-sd-highspeed   : indicates whether SD is high speed capable.
+
 Example:
 
 sdi0_per1@80126000 {
@@ -42,8 +44,8 @@  sdi0_per1@80126000 {
 
 	max-frequency = <100000000>;
 	bus-width = <4>;
-	mmc-cap-sd-highspeed;
-	mmc-cap-mmc-highspeed;
+	cap-sd-highspeed;
+	cap-mmc-highspeed;
 	cd-gpios  = <&gpio2 31 0x4>; // 95
 	st,sig-dir-dat0;
 	st,sig-dir-dat2;