| Message ID | 1400230143-15620-4-git-send-email-valentin.longchamp@keymile.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
diff --git a/arch/arm/boot/dts/kirkwood-km_fixedeth.dts b/arch/arm/boot/dts/kirkwood-km_fixedeth.dts new file mode 100644 index 0000000..9895f2b --- /dev/null +++ b/arch/arm/boot/dts/kirkwood-km_fixedeth.dts @@ -0,0 +1,23 @@ +/dts-v1/; + +#include "kirkwood.dtsi" +#include "kirkwood-98dx4122.dtsi" +#include "kirkwood-km_common.dtsi" + +/ { + model = "Keymile Kirkwood Fixed Eth"; + compatible = "keymile,km_fixedeth", "marvell,kirkwood-98DX4122", "marvell,kirkwood"; + + memory { + device_type = "memory"; + reg = <0x00000000 0x10000000>; + }; +}; + +ð0 { + status = "okay"; + ethernet0-port@0 { + speed = <1000>; /* <SPEED_1000> */ + duplex = <1>; /* <DUPLEX_FULL> */ + }; +};
Besides our Kirkwood Reference design, there is another group of board on which the eth interface is not connected to a phy but to a switch for some board internal communication. For these designs, the memory also is raised to 256MB. The configuration of the switch is handled by an EEPROM or by the bootloader, but on the kirkwood side, the port is always configured as 1000 Mbits, full duplex. Signed-off-by: Valentin Longchamp <valentin.longchamp@keymile.com> --- Changes in v2: - Take advantage of the kirkwood-km_common.dtsi file for kirkwood-km_fixedeth.dts arch/arm/boot/dts/kirkwood-km_fixedeth.dts | 23 +++++++++++++++++++++++ 1 file changed, 23 insertions(+) create mode 100644 arch/arm/boot/dts/kirkwood-km_fixedeth.dts