@@ -43,6 +43,7 @@
* OTHER DEALINGS IN THE SOFTWARE.
*/
+#include <dt-bindings/gpio/meson8-gpio.h>
/include/ "meson.dtsi"
/ {
@@ -89,4 +90,71 @@
compatible = "fixed-clock";
clock-frequency = <141666666>;
};
+
+ pinctrl: pinctrl@c1109880 {
+ compatible = "amlogic,meson8-pinctrl";
+ reg = <0xc1109880 0x10>;
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges;
+
+ gpio: banks@c11080b0 {
+ reg = <0xc11080b0 0x28>,
+ <0xc11080e8 0x18>,
+ <0xc1108120 0x18>,
+ <0xc1108030 0x30>;
+ reg-names = "mux", "pull", "pull-enable", "gpio";
+ gpio-controller;
+ #gpio-cells = <2>;
+ };
+
+ gpio_ao: ao-bank@c1108030 {
+ reg = <0xc8100014 0x4>,
+ <0xc810002c 0x4>,
+ <0xc8100024 0x8>;
+ reg-names = "mux", "pull", "gpio";
+ gpio-controller;
+ #gpio-cells = <2>;
+ };
+
+ uart_ao_a_pins: uart_ao_a {
+ mux {
+ groups = "uart_tx_ao_a", "uart_rx_ao_a";
+ function = "uart_ao";
+ };
+ };
+
+ i2c_ao_pins: i2c_mst_ao {
+ mux {
+ groups = "i2c_mst_sck_ao", "i2c_mst_sda_ao";
+ function = "i2c_mst_ao";
+ };
+ };
+
+ spi_nor_pins: nor {
+ mux {
+ groups = "nor_d", "nor_q", "nor_c", "nor_cs";
+ function = "nor";
+ };
+ };
+
+ ir_recv_pins: remote {
+ mux {
+ groups = "remote_input";
+ function = "remote";
+ };
+ };
+
+ eth_pins: ethernet {
+ mux {
+ groups = "eth_tx_clk_50m", "eth_tx_en",
+ "eth_txd1", "eth_txd0",
+ "eth_rx_clk_in", "eth_rx_dv",
+ "eth_rxd1", "eth_rxd0", "eth_mdio",
+ "eth_mdc";
+ function = "ethernet";
+ };
+ };
+ };
+
}; /* end of / */
Add pinctrl node to the DTSI file for meson8 and sub-nodes for some standard mux configurations. Signed-off-by: Beniamino Galvani <b.galvani@gmail.com> --- arch/arm/boot/dts/meson8.dtsi | 68 +++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 68 insertions(+)