@@ -163,6 +163,7 @@ static void xspi_rx32(struct xilinx_spi *xspi)
static void xspi_init_hw(struct xilinx_spi *xspi)
{
void __iomem *regs_base = xspi->regs;
+ u32 inhibit;
/* Reset the SPI device */
xspi->write_fn(XIPIF_V123B_RESET_MASK,
@@ -173,16 +174,19 @@ static void xspi_init_hw(struct xilinx_spi *xspi)
xspi->write_fn(XSPI_INTR_TX_EMPTY,
regs_base + XIPIF_V123B_IIER_OFFSET);
/* Enable the global IPIF interrupt */
- if (xspi->irq >= 0)
+ if (xspi->irq >= 0) {
xspi->write_fn(XIPIF_V123B_GINTR_ENABLE,
regs_base + XIPIF_V123B_DGIER_OFFSET);
- else
+ inhibit = XSPI_CR_TRANS_INHIBIT;
+ } else {
xspi->write_fn(0, regs_base + XIPIF_V123B_DGIER_OFFSET);
+ inhibit = 0;
+ }
/* Deselect the slave on the SPI bus */
xspi->write_fn(0xffff, regs_base + XSPI_SSR_OFFSET);
/* Disable the transmitter, enable Manual Slave Select Assertion,
* put SPI controller into master mode, and enable it */
- xspi->write_fn(XSPI_CR_TRANS_INHIBIT | XSPI_CR_MANUAL_SSELECT |
+ xspi->write_fn(inhibit | XSPI_CR_MANUAL_SSELECT |
XSPI_CR_MASTER_MODE | XSPI_CR_ENABLE | XSPI_CR_TXFIFO_RESET |
XSPI_CR_RXFIFO_RESET, regs_base + XSPI_CR_OFFSET);
}
@@ -252,7 +256,7 @@ static int xilinx_spi_txrx_bufs(struct spi_device *spi, struct spi_transfer *t)
reinit_completion(&xspi->done);
while (xspi->remaining_bytes) {
- u16 cr;
+ u16 cr = 0;
int n_words;
n_words = (xspi->remaining_bytes * 8) / xspi->bits_per_word;
@@ -263,13 +267,13 @@ static int xilinx_spi_txrx_bufs(struct spi_device *spi, struct spi_transfer *t)
/* Start the transfer by not inhibiting the transmitter any
* longer
*/
- cr = xspi->read_fn(xspi->regs + XSPI_CR_OFFSET) &
- ~XSPI_CR_TRANS_INHIBIT;
- xspi->write_fn(cr, xspi->regs + XSPI_CR_OFFSET);
- if (xspi->irq >= 0)
+ if (xspi->irq >= 0) {
+ cr = xspi->read_fn(xspi->regs + XSPI_CR_OFFSET) &
+ ~XSPI_CR_TRANS_INHIBIT;
+ xspi->write_fn(cr, xspi->regs + XSPI_CR_OFFSET);
wait_for_completion(&xspi->done);
- else
+ } else
while (!(xspi->read_fn(xspi->regs + XSPI_SR_OFFSET) &
XSPI_SR_TX_EMPTY_MASK))
;
@@ -279,7 +283,8 @@ static int xilinx_spi_txrx_bufs(struct spi_device *spi, struct spi_transfer *t)
* transmitter while the Isr refills the transmit register/FIFO,
* or make sure it is stopped if we're done.
*/
- xspi->write_fn(cr | XSPI_CR_TRANS_INHIBIT,
+ if (xspi->irq >= 0)
+ xspi->write_fn(cr | XSPI_CR_TRANS_INHIBIT,
xspi->regs + XSPI_CR_OFFSET);
/* Read out all the data from the Rx FIFO */
When no irq is used, there is no need to inhibit the transmission for every transaction. This inhibition was implemented to avoid a race condition with the irq handler. Signed-off-by: Ricardo Ribalda Delgado <ricardo.ribalda@gmail.com> --- drivers/spi/spi-xilinx.c | 25 +++++++++++++++---------- 1 file changed, 15 insertions(+), 10 deletions(-)