@@ -32,6 +32,7 @@
#include "sdhci-esdhc.h"
#define ESDHC_CTRL_D3CD 0x08
+#define ESDHC_BURST_LEN_EN_INCR (1 << 27)
/* VENDOR SPEC register */
#define ESDHC_VENDOR_SPEC 0xc0
#define ESDHC_VENDOR_SPEC_SDIO_QUIRK (1 << 1)
@@ -1165,6 +1166,21 @@ static int sdhci_esdhc_imx_probe(struct platform_device *pdev)
host->quirks2 |= SDHCI_QUIRK2_PRESET_VALUE_BROKEN;
host->mmc->caps |= MMC_CAP_1_8V_DDR;
+ /*
+ * ROM code will change the bit burst_length_enable setting
+ * to zero if this usdhc is choosed to boot system. Change
+ * it back here, otherwise it will impact the performance a
+ * lot. This bit is used to enable/disable the burst length
+ * for the external AHB2AXI bridge, it's usefully especially
+ * for INCR transfer because without burst length indicator,
+ * the AHB2AXI bridge does not know the burst length in
+ * advance. And without burst length indicator, AHB INCR
+ * transfer can only be converted to singles on the AXI side.
+ */
+ writel(readl(host->ioaddr + SDHCI_HOST_CONTROL)
+ | ESDHC_BURST_LEN_EN_INCR,
+ host->ioaddr + SDHCI_HOST_CONTROL);
+
if (!(imx_data->socdata->flags & ESDHC_FLAG_HS200))
host->quirks2 |= SDHCI_QUIRK2_BROKEN_HS200;
Currently we find that if a usdhc is choosed to boot system, then ROM code will set the burst length enable bit of this usdhc as 0. This will make performance drop a lot if this usdhc's burst length is configed. So this patch set back the burst_length_enable bit as 1, which is the default value, and means burst length is enabled for INCR. Signed-off-by: Haibo Chen <haibo.chen@freescale.com> --- drivers/mmc/host/sdhci-esdhc-imx.c | 16 ++++++++++++++++ 1 file changed, 16 insertions(+)