@@ -115,12 +115,16 @@ static void uniphier_serial_out(struct uart_port *p, int offset, int value)
*/
static int uniphier_serial_dl_read(struct uart_8250_port *up)
{
- return readl(up->port.membase + UNIPHIER_UART_DLR);
+ int offset = UNIPHIER_UART_DLR << up->port.regshift;
+
+ return readl(up->port.membase + offset);
}
static void uniphier_serial_dl_write(struct uart_8250_port *up, int value)
{
- writel(value, up->port.membase + UNIPHIER_UART_DLR);
+ int offset = UNIPHIER_UART_DLR << up->port.regshift;
+
+ writel(value, up->port.membase + offset);
}
static int uniphier_of_serial_setup(struct device *dev, struct uart_port *port,
The register offset must be shifted by regshift, otherwise the baudrate is not set. I missed the issue probably because the divisor register was already set by the boot loader. Fixes: 1a8d2903cb6a ("serial: 8250_uniphier: add UniPhier serial driver") Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com> --- Hi Greg, Please apply this simple fix for Linux 4.3. Thanks, Masahiro drivers/tty/serial/8250/8250_uniphier.c | 8 ++++++-- 1 file changed, 6 insertions(+), 2 deletions(-)