@@ -45,6 +45,7 @@
#include <dt-bindings/interrupt-controller/irq.h>
#include <dt-bindings/interrupt-controller/arm-gic.h>
#include <dt-bindings/pinctrl/rockchip.h>
+#include <dt-bindings/thermal/thermal.h>
/ {
compatible = "rockchip,rk3368";
@@ -123,6 +124,8 @@
reg = <0x0 0x0>;
cpu-idle-states = <&cpu_sleep>;
enable-method = "psci";
+
+ #cooling-cells = <2>; /* min followed by max */
};
cpu_l1: cpu@1 {
@@ -155,6 +158,8 @@
reg = <0x0 0x100>;
cpu-idle-states = <&cpu_sleep>;
enable-method = "psci";
+
+ #cooling-cells = <2>; /* min followed by max */
};
cpu_b1: cpu@101 {
@@ -404,6 +409,27 @@
status = "disabled";
};
+ thermal-zones {
+ #include "rk3368-thermal.dtsi"
+ };
+
+ tsadc: tsadc@ff280000 {
+ compatible = "rockchip,rk3368-tsadc";
+ reg = <0x0 0xff280000 0x0 0x100>;
+ interrupts = <GIC_SPI 37 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&cru SCLK_TSADC>, <&cru PCLK_TSADC>;
+ clock-names = "tsadc", "apb_pclk";
+ resets = <&cru SRST_TSADC>;
+ reset-names = "tsadc-apb";
+ pinctrl-names = "init", "default", "sleep";
+ pinctrl-0 = <&otp_gpio>;
+ pinctrl-1 = <&otp_out>;
+ pinctrl-2 = <&otp_gpio>;
+ #thermal-sensor-cells = <1>;
+ rockchip,hw-tshut-temp = <95000>;
+ status = "disabled";
+ };
+
gmac: ethernet@ff290000 {
compatible = "rockchip,rk3368-gmac";
reg = <0x0 0xff290000 0x0 0x10000>;
@@ -829,6 +855,16 @@
};
};
+ tsadc {
+ otp_out: otp-gpio {
+ rockchip,pins = <0 10 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+
+ otp_out: otp-out {
+ rockchip,pins = <0 10 RK_FUNC_1 &pcfg_pull_none>;
+ };
+ };
+
uart0 {
uart0_xfer: uart0-xfer {
rockchip,pins = <2 24 RK_FUNC_1 &pcfg_pull_up>,
This patch add the thermal needed info on RK3368. Meanwhile, support the trips to throttle for thermal. Signed-off-by: Caesar Wang <wxt@rock-chips.com> --- Changes in v1: - support the opt gpio pinctrl state arch/arm64/boot/dts/rockchip/rk3368.dtsi | 36 ++++++++++++++++++++++++++++++++ 1 file changed, 36 insertions(+)