@@ -57,6 +57,7 @@
#define AML_UART_RX_EMPTY BIT(20)
#define AML_UART_TX_FULL BIT(21)
#define AML_UART_TX_EMPTY BIT(22)
+#define AML_UART_XMIT_BUSY BIT(25)
#define AML_UART_ERR (AML_UART_PARITY_ERR | \
AML_UART_FRAME_ERR | \
AML_UART_TX_FIFO_WERR)
@@ -100,7 +101,8 @@ static unsigned int meson_uart_tx_empty(struct uart_port *port)
u32 val;
val = readl(port->membase + AML_UART_STATUS);
- return (val & AML_UART_TX_EMPTY) ? TIOCSER_TEMT : 0;
+ val &= (AML_UART_TX_EMPTY | AML_UART_XMIT_BUSY);
+ return (val == AML_UART_TX_EMPTY) ? TIOCSER_TEMT : 0;
}
static void meson_uart_stop_tx(struct uart_port *port)
The tx_empty() uart_op should only return empty if both the transmit fifo and the transmit state-machine are both idle. Add a test for the hardware's XMIT_BUSY flag. Note, this is possibly related to an issue where the port is being shutdown with paritally transmitted characters in it. Signed-off-by: Ben Dooks <ben.dooks@codethink.co.uk> Reported-by: Edward Cragg <edward.cragg@codethink.co.uk> --- drivers/tty/serial/meson_uart.c | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-)