diff mbox

[1/4] ARM: dts: qcom: apq8064-ifc6410 Use hardware flow control for GSBI6

Message ID 1449858598-13429-1-git-send-email-srinivas.kandagatla@linaro.org (mailing list archive)
State New, archived
Headers show

Commit Message

Srinivas Kandagatla Dec. 11, 2015, 6:29 p.m. UTC 
From: "Ivan T. Ivanov" <ivan.ivanov@linaro.org>

GSBI6 UART module is connected to BT chip, which uses
hardware flow control lines. Enable them on SoC side.

Signed-off-by: Ivan T. Ivanov <ivan.ivanov@linaro.org>
---
 arch/arm/boot/dts/qcom-apq8064-ifc6410.dts | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

Comments

Andy Gross Dec. 11, 2015, 7:24 p.m. UTC | #1 
On Fri, Dec 11, 2015 at 06:29:58PM +0000, Srinivas Kandagatla wrote:
> From: "Ivan T. Ivanov" <ivan.ivanov@linaro.org>
> 
> GSBI6 UART module is connected to BT chip, which uses
> hardware flow control lines. Enable them on SoC side.
> 
> Signed-off-by: Ivan T. Ivanov <ivan.ivanov@linaro.org>

Looks fine to me. Thanks for the patch.
diff mbox

Patch

diff --git a/arch/arm/boot/dts/qcom-apq8064-ifc6410.dts b/arch/arm/boot/dts/qcom-apq8064-ifc6410.dts
index 11ac608..80c6695 100644
--- a/arch/arm/boot/dts/qcom-apq8064-ifc6410.dts
+++ b/arch/arm/boot/dts/qcom-apq8064-ifc6410.dts
@@ -164,7 +164,7 @@ 
 
 		gsbi@16500000 {
 			status = "ok";
-			qcom,mode = <GSBI_PROT_I2C_UART>;
+			qcom,mode = <GSBI_PROT_UART_W_FC>;
 
 			serial@16540000 {
 				status = "ok";