@@ -443,6 +443,8 @@ struct bcm2835_clock_data {
/* Number of fractional bits in the divider */
u32 frac_bits;
+ u32 flags;
+
bool is_vpu_clock;
bool is_mash_clock;
};
@@ -1230,7 +1232,7 @@ static struct clk *bcm2835_register_clock(struct bcm2835_cprman *cprman,
init.parent_names = parents;
init.num_parents = data->num_mux_parents;
init.name = data->name;
- init.flags = CLK_IGNORE_UNUSED;
+ init.flags = data->flags | CLK_IGNORE_UNUSED;
if (data->is_vpu_clock) {
init.ops = &bcm2835_vpu_clock_clk_ops;
@@ -1649,6 +1651,7 @@ static const struct bcm2835_clk_desc clk_desc_array[] = {
.div_reg = CM_VPUDIV,
.int_bits = 12,
.frac_bits = 8,
+ .flags = CLK_IS_CRITICAL,
.is_vpu_clock = true),
/* clocks with per parent mux */
The VPU clock is also the clock for our AXI bus, so we really can't disable it. This might have happened during boot if, for example, uart1 (aux_uart clock) probed and was then disabled before the other consumers of the VPU clock had probed. Signed-off-by: Eric Anholt <eric@anholt.net> --- v2: Rewrite to use a .flags in bcm2835_clock_data, since other clocks will need this too. drivers/clk/bcm/clk-bcm2835.c | 5 ++++- 1 file changed, 4 insertions(+), 1 deletion(-)