diff mbox

[2/2] ARM: dts: sd_600eval: Fix eMMC lockup issue

Message ID 1465551298-21457-2-git-send-email-srinivas.kandagatla@linaro.org (mailing list archive)
State New, archived
Headers show

Commit Message

Srinivas Kandagatla June 10, 2016, 9:34 a.m. UTC 
From: Parth Pancholi <parth.pancholi@einfochips.com>

This board locks up if we stress test the eMMC, as the regulator s4 is
unable to supply enough current for all the peripherials attached to it.
As this supply is wired up to most of the peripherials including DDR,
it resulted in such lockup.

This patch fixes this issue by setting s4 regulator correctly with
Auto power mode.

Reported-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
[Srinivas Kandagatla: rewrote the change log]
Tested-by: Girish Sharma <girish.sharma@einfochips.com>
Signed-off-by: Parth Pancholi <parth.pancholi@einfochips.com>
---
 arch/arm/boot/dts/qcom-apq8064-arrow-sd-600eval.dts | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)
diff mbox

Patch

diff --git a/arch/arm/boot/dts/qcom-apq8064-arrow-sd-600eval.dts b/arch/arm/boot/dts/qcom-apq8064-arrow-sd-600eval.dts
index 7df0108..39ae2bc 100644
--- a/arch/arm/boot/dts/qcom-apq8064-arrow-sd-600eval.dts
+++ b/arch/arm/boot/dts/qcom-apq8064-arrow-sd-600eval.dts
@@ -1,6 +1,7 @@ 
 #include "qcom-apq8064-v2.0.dtsi"
 #include "qcom-apq8064-arrow-sd-600eval-pins.dtsi"
 #include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/mfd/qcom-rpm.h>
 
 / {
 	model = "Arrow Electronics, APQ8064 SD_600eval";
@@ -82,7 +83,8 @@ 
 				s4 {
 					regulator-min-microvolt	= <1800000>;
 					regulator-max-microvolt	= <1800000>;
-					qcom,switch-mode-frequency = <3200000>;
+					qcom,switch-mode-frequency = <1600000>;
+					qcom,force-mode = <QCOM_RPM_FORCE_MODE_AUTO>;
 					bias-pull-down;
 					regulator-always-on;
 				};