@@ -44,7 +44,7 @@
#include "sun8i-h3-orangepi-2.dts"
/ {
- model = "Xunlong Orange Pi Plus";
+ model = "Xunlong Orange Pi Plus / Plus 2 / Plus 2E";
compatible = "xunlong,orangepi-plus", "allwinner,sun8i-h3";
reg_usb3_vbus: usb3-vbus {
@@ -60,6 +60,10 @@
};
};
+&ehci2 {
+ status = "okay";
+};
+
&ehci3 {
status = "okay";
};
@@ -81,6 +85,18 @@
allwinner,pull = <SUN4I_PINCTRL_PULL_UP>;
};
+&ohci1 {
+ status = "okay";
+};
+
+&ohci2 {
+ status = "okay";
+};
+
+&ohci3 {
+ status = "okay";
+};
+
&pio {
usb3_vbus_pin_a: usb3_vbus_pin@0 {
allwinner,pins = "PG11";
There is a new Orange Pi Plus 2E available now, rather then adding yet another dts file for this variant, extend the existing Plus / Plus2 dt to also support this variant. The 2E goes from 4 to 3 USB ports and drops the sata connector, so it no longer has a USB hub or an USB <-> sata bridge on the board. This commit enables all 3 ehci and ohci controllers to support the 3 USB connectors which are now directly connected to the SoC. Downside of this approach is 4 unused USB busses now showing up on the original Plus / Plus 2. Signed-off-by: Hans de Goede <hdegoede@redhat.com> --- arch/arm/boot/dts/sun8i-h3-orangepi-plus.dts | 18 +++++++++++++++++- 1 file changed, 17 insertions(+), 1 deletion(-)