diff mbox

[V2,11/15] mmc: sdhci-esdhc-imx: fix strobe DLL lock wrong clock issue

Message ID 1468309584-3591-12-git-send-email-aisheng.dong@nxp.com (mailing list archive)
State New, archived
Headers show

Commit Message

Aisheng Dong July 12, 2016, 7:46 a.m. UTC 
When enable DDR, the clock factor definition is changed.
e.g. original 200Mhz will become 100Mhz once MIX_CTRL_DDREN bit is set
So we need to update the clock setting then the strobe dll can lock
the correct clock rate.

Additionally we also need disable the clock before locking strobe dll.

Acked-by: Adrian Hunter <adrian.hunter@intel.com>
Signed-off-by: Dong Aisheng <aisheng.dong@nxp.com>
---
 drivers/mmc/host/sdhci-esdhc-imx.c | 7 +++++++
 1 file changed, 7 insertions(+)
diff mbox

Patch

diff --git a/drivers/mmc/host/sdhci-esdhc-imx.c b/drivers/mmc/host/sdhci-esdhc-imx.c
index ac2c83af7440..bbb0bd4eac28 100644
--- a/drivers/mmc/host/sdhci-esdhc-imx.c
+++ b/drivers/mmc/host/sdhci-esdhc-imx.c
@@ -853,6 +853,11 @@  static void esdhc_set_strobe_dll(struct sdhci_host *host)
 	u32 v;
 
 	if (host->mmc->actual_clock > ESDHC_STROBE_DLL_CLK_FREQ) {
+		/* disable clock before enabling strobe dll */
+		writel(readl(host->ioaddr + ESDHC_VENDOR_SPEC) &
+		       ~ESDHC_VENDOR_SPEC_FRC_SDCLK_ON,
+		       host->ioaddr + ESDHC_VENDOR_SPEC);
+
 		/* force a reset on strobe dll */
 		writel(ESDHC_STROBE_DLL_CTRL_RESET,
 			host->ioaddr + ESDHC_STROBE_DLL_CTRL);
@@ -914,6 +919,8 @@  static void esdhc_set_uhs_signaling(struct sdhci_host *host, unsigned timing)
 		m |= ESDHC_MIX_CTRL_DDREN | ESDHC_MIX_CTRL_HS400_EN;
 		writel(m, host->ioaddr + ESDHC_MIX_CTRL);
 		imx_data->is_ddr = 1;
+		/* update clock after enable DDR for strobe DLL lock */
+		host->ops->set_clock(host, host->clock);
 		esdhc_set_strobe_dll(host);
 		break;
 	}