| Message ID | 1471337998-6467-2-git-send-email-wenyou.yang@atmel.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
Hi, On Tue, Aug 16, 2016 at 04:59:52PM +0800, Wenyou Yang wrote: > [...] > > -static int act8945a_get_battery_health(struct act8945a_charger *charger, > - struct regmap *regmap, int *val) > +static int act8945a_get_battery_health(struct regmap *regmap, int *val) > { > int ret; > unsigned int status; > @@ -148,7 +146,7 @@ static int act8945a_get_battery_health(struct act8945a_charger *charger, > if (ret < 0) > return ret; > > - if (charger->battery_temperature && !(status & APCH_STATUS_TEMPDAT)) > + if (status & APCH_STATUS_TEMPDAT) This incorrectly inverts the logic. > *val = POWER_SUPPLY_HEALTH_OVERHEAT; > else if (!(status & APCH_STATUS_INDAT)) > *val = POWER_SUPPLY_HEALTH_OVERVOLTAGE; > @@ -188,8 +186,7 @@ static int act8945a_charger_get_property(struct power_supply *psy, > val->intval = POWER_SUPPLY_TECHNOLOGY_LION; > break; > case POWER_SUPPLY_PROP_HEALTH: > - ret = act8945a_get_battery_health(charger, > - regmap, &val->intval); > + ret = act8945a_get_battery_health(regmap, &val->intval); > break; > case POWER_SUPPLY_PROP_MODEL_NAME: > val->strval = act8945a_charger_model; > @@ -235,9 +232,6 @@ static int act8945a_charger_config(struct device *dev, > return -EINVAL; > } > > - charger->battery_temperature = of_property_read_bool(np, > - "active-semi,check-battery-temperature"); > - > chglev_pin = of_get_named_gpio_flags(np, > "active-semi,chglev-gpios", 0, &flags); -- Sebastian
diff --git a/drivers/power/supply/act8945a_charger.c b/drivers/power/supply/act8945a_charger.c index b5c00e4..72d39ba 100644 --- a/drivers/power/supply/act8945a_charger.c +++ b/drivers/power/supply/act8945a_charger.c @@ -76,7 +76,6 @@ static const char *act8945a_charger_manufacturer = "Active-semi"; struct act8945a_charger { struct regmap *regmap; - bool battery_temperature; }; static int act8945a_get_charger_state(struct regmap *regmap, int *val) @@ -138,8 +137,7 @@ static int act8945a_get_charge_type(struct regmap *regmap, int *val) return 0; } -static int act8945a_get_battery_health(struct act8945a_charger *charger, - struct regmap *regmap, int *val) +static int act8945a_get_battery_health(struct regmap *regmap, int *val) { int ret; unsigned int status; @@ -148,7 +146,7 @@ static int act8945a_get_battery_health(struct act8945a_charger *charger, if (ret < 0) return ret; - if (charger->battery_temperature && !(status & APCH_STATUS_TEMPDAT)) + if (status & APCH_STATUS_TEMPDAT) *val = POWER_SUPPLY_HEALTH_OVERHEAT; else if (!(status & APCH_STATUS_INDAT)) *val = POWER_SUPPLY_HEALTH_OVERVOLTAGE; @@ -188,8 +186,7 @@ static int act8945a_charger_get_property(struct power_supply *psy, val->intval = POWER_SUPPLY_TECHNOLOGY_LION; break; case POWER_SUPPLY_PROP_HEALTH: - ret = act8945a_get_battery_health(charger, - regmap, &val->intval); + ret = act8945a_get_battery_health(regmap, &val->intval); break; case POWER_SUPPLY_PROP_MODEL_NAME: val->strval = act8945a_charger_model; @@ -235,9 +232,6 @@ static int act8945a_charger_config(struct device *dev, return -EINVAL; } - charger->battery_temperature = of_property_read_bool(np, - "active-semi,check-battery-temperature"); - chglev_pin = of_get_named_gpio_flags(np, "active-semi,chglev-gpios", 0, &flags);
Remove "battery_temperature" member, it is redundant, it is the hardware's responsibility to handle TH pin properly. It is unnecessary to use the dt property to check if there is a battery temperature monitor or not. Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com> --- Changes in v5: None Changes in v4: None Changes in v3: None Changes in v2: None drivers/power/supply/act8945a_charger.c | 12 +++--------- 1 file changed, 3 insertions(+), 9 deletions(-)