@@ -58,6 +58,17 @@
#clock-cells = <0>;
};
+ vcc_host: vcc-host-regulator {
+ compatible = "regulator-fixed";
+ enable-active-high;
+ gpio = <&gpio3 RK_PC4 GPIO_ACTIVE_HIGH>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&host_vbus_drv>;
+ regulator-name = "vcc_host";
+ regulator-always-on;
+ regulator-boot-on;
+ };
+
vcc_phy: vcc-phy-regulator {
compatible = "regulator-fixed";
enable-active-high;
@@ -85,6 +96,69 @@
status = "okay";
};
+&pinctrl {
+ usb {
+ host_vbus_drv: host-vbus-drv {
+ rockchip,pins = <3 RK_PC4 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+ };
+};
+
&uart2 {
status = "okay";
};
+
+&u2phy0 {
+ status = "okay";
+
+ u2phy0_otg: otg-port {
+ status = "okay";
+ };
+
+ u2phy0_host: host-port {
+ phy-supply = <&vcc_host>;
+ status = "okay";
+ };
+};
+
+&u2phy1 {
+ status = "okay";
+
+ u2phy1_otg: otg-port {
+ phy-supply = <&vcc_host>;
+ status = "okay";
+ };
+
+ u2phy1_host: host-port {
+ phy-supply = <&vcc_host>;
+ status = "okay";
+ };
+};
+
+&usb_host0_ehci {
+ status = "okay";
+};
+
+&usb_host0_ohci {
+ status = "okay";
+};
+
+&usb_host1_ehci {
+ status = "okay";
+};
+
+&usb_host1_ohci {
+ status = "okay";
+};
+
+&usb_host2_ehci {
+ status = "okay";
+};
+
+&usb_host2_ohci {
+ status = "okay";
+};
+
+&usb_otg {
+ status = "okay";
+};
Rockchip's rk3229 evaluation board has one usb otg controller and three usb host controllers. Each usb controller connect with one usb2 phy port through UTMI+ interface. And the three usb host interfaces use the same GPIO VBUS drive. Let's enable them to support usb on rk3229 evb board. Signed-off-by: William Wu <william.wu@rock-chips.com> --- arch/arm/boot/dts/rk3229-evb.dts | 74 ++++++++++++++++++++++++++++++++++++++++ 1 file changed, 74 insertions(+)