diff mbox

[RESEND,v4,3/3] ARM: dts: exynos: Remove the display-timing and delay from rinato dts

Message ID 1505703264-6704-1-git-send-email-hoegeun.kwon@samsung.com (mailing list archive)
State New, archived
Headers show

Commit Message

Hoegeun Kwon Sept. 18, 2017, 2:54 a.m. UTC
The display-timing and delay are included in the panel driver. So it
 should be removed in dts.

Signed-off-by: Hoegeun Kwon <hoegeun.kwon@samsung.com>
---

Hi Krzysztof,

This patch was rebased to the mainline (v4.14-rc1).

Best regards,
Hoegeun

 arch/arm/boot/dts/exynos3250-rinato.dts | 22 ----------------------
 1 file changed, 22 deletions(-)

Comments

Krzysztof Kozlowski Sept. 18, 2017, 5:06 p.m. UTC | #1
On Mon, Sep 18, 2017 at 11:54:24AM +0900, Hoegeun Kwon wrote:
>  The display-timing and delay are included in the panel driver. So it
>  should be removed in dts.
> 
> Signed-off-by: Hoegeun Kwon <hoegeun.kwon@samsung.com>
> ---
> 
> Hi Krzysztof,
> 
> This patch was rebased to the mainline (v4.14-rc1).
> 
> Best regards,
> Hoegeun
> 
>  arch/arm/boot/dts/exynos3250-rinato.dts | 22 ----------------------
>  1 file changed, 22 deletions(-)
> 

Thanks, applied.

Best regards,
Krzysztof
diff mbox

Patch

diff --git a/arch/arm/boot/dts/exynos3250-rinato.dts b/arch/arm/boot/dts/exynos3250-rinato.dts
index 0b45467..ff792ff 100644
--- a/arch/arm/boot/dts/exynos3250-rinato.dts
+++ b/arch/arm/boot/dts/exynos3250-rinato.dts
@@ -227,28 +227,6 @@ 
 		vci-supply = <&ldo20_reg>;
 		reset-gpios = <&gpe0 1 GPIO_ACTIVE_LOW>;
 		te-gpios = <&gpx0 6 GPIO_ACTIVE_HIGH>;
-		power-on-delay= <30>;
-		power-off-delay= <120>;
-		reset-delay = <5>;
-		init-delay = <100>;
-		flip-horizontal;
-		flip-vertical;
-		panel-width-mm = <29>;
-		panel-height-mm = <29>;
-
-		display-timings {
-			timing-0 {
-				clock-frequency = <4600000>;
-				hactive = <320>;
-				vactive = <320>;
-				hfront-porch = <1>;
-				hback-porch = <1>;
-				hsync-len = <1>;
-				vfront-porch = <150>;
-				vback-porch = <1>;
-				vsync-len = <2>;
-			};
-		};
 	};
 };