| Message ID | 1558711838-21174-1-git-send-email-erwan.leray@st.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
| Series | [1/1] dt-bindings: stm32: serial: Add optional reset | expand |
On Fri, 24 May 2019 17:30:38 +0200, Erwan Le Ray wrote: > STM32 serial can be reset via reset controller. > Add an optional reset property to stm32 usart bindings. > > Signed-off-by: Erwan Le Ray <erwan.leray@st.com> > Applied, thanks. Rob
diff --git a/Documentation/devicetree/bindings/serial/st,stm32-usart.txt b/Documentation/devicetree/bindings/serial/st,stm32-usart.txt index 9d3efed..a6b1948 100644 --- a/Documentation/devicetree/bindings/serial/st,stm32-usart.txt +++ b/Documentation/devicetree/bindings/serial/st,stm32-usart.txt @@ -13,6 +13,7 @@ Required properties: - clocks: The input clock of the USART instance Optional properties: +- resets: Must contain the phandle to the reset controller. - pinctrl: The reference on the pins configuration - st,hw-flow-ctrl: bool flag to enable hardware flow control. - rs485-rts-delay, rs485-rx-during-tx, rs485-rts-active-low,
STM32 serial can be reset via reset controller. Add an optional reset property to stm32 usart bindings. Signed-off-by: Erwan Le Ray <erwan.leray@st.com>