diff mbox series

[1/2] ARM: dts: stm32: remove OV5640 pinctrl definition on stm32mp157c-ev1

Message ID 1564054607-2028-2-git-send-email-amelie.delaunay@st.com (mailing list archive)
State Mainlined
Commit afe3af89cd38ebab2e432a54590acb262c3e15ac
Headers show
Series STMFX GPIO consumers update | expand

Commit Message

Amelie Delaunay July 25, 2019, 11:36 a.m. UTC 
From: Alexandre Torgue <alexandre.torgue@st.com>

"push-pull" configuration is now fully handled by the gpiolib and the
STMFX pinctrl driver. There is no longer need to declare a pinctrl group
to only configure "push-pull" setting for the line. It is done directly by
the gpiolib.

Signed-off-by: Alexandre Torgue <alexandre.torgue@st.com>
Signed-off-by: Amelie Delaunay <amelie.delaunay@st.com>
---
 arch/arm/boot/dts/stm32mp157c-ev1.dts | 12 ++----------
 1 file changed, 2 insertions(+), 10 deletions(-)
diff mbox series

Patch

diff --git a/arch/arm/boot/dts/stm32mp157c-ev1.dts b/arch/arm/boot/dts/stm32mp157c-ev1.dts
index 9ab25da..e4b04dd 100644
--- a/arch/arm/boot/dts/stm32mp157c-ev1.dts
+++ b/arch/arm/boot/dts/stm32mp157c-ev1.dts
@@ -182,14 +182,12 @@ 
 
 	ov5640: camera@3c {
 		compatible = "ovti,ov5640";
-		pinctrl-names = "default";
-		pinctrl-0 = <&ov5640_pins>;
 		reg = <0x3c>;
 		clocks = <&clk_ext_camera>;
 		clock-names = "xclk";
 		DOVDD-supply = <&v2v8>;
-		powerdown-gpios = <&stmfx_pinctrl 18 GPIO_ACTIVE_HIGH>;
-		reset-gpios = <&stmfx_pinctrl 19 GPIO_ACTIVE_LOW>;
+		powerdown-gpios = <&stmfx_pinctrl 18 (GPIO_ACTIVE_HIGH | GPIO_PUSH_PULL)>;
+		reset-gpios = <&stmfx_pinctrl 19 (GPIO_ACTIVE_LOW | GPIO_PUSH_PULL)>;
 		rotation = <180>;
 		status = "okay";
 
@@ -225,12 +223,6 @@ 
 				drive-push-pull;
 				bias-pull-down;
 			};
-
-			ov5640_pins: camera {
-				pins = "agpio2", "agpio3"; /* stmfx pins 18 & 19 */
-				drive-push-pull;
-				output-low;
-			};
 		};
 	};
 };