@@ -1215,6 +1215,9 @@ usdhc1: mmc@30b40000 {
"fsl,imx7d-usdhc";
reg = <0x30b40000 0x10000>;
interrupts = <GIC_SPI 22 IRQ_TYPE_LEVEL_HIGH>;
+ interconnects = <&icc IMX8MQ_ICM_USDHC1 &icc IMX8MQ_ICS_DRAM>;
+ interconnect-names = "path";
+ fsl,icc-rate = <266666>;
clocks = <&clk IMX8MQ_CLK_IPG_ROOT>,
<&clk IMX8MQ_CLK_NAND_USDHC_BUS>,
<&clk IMX8MQ_CLK_USDHC1_ROOT>;
@@ -1230,6 +1233,9 @@ usdhc2: mmc@30b50000 {
"fsl,imx7d-usdhc";
reg = <0x30b50000 0x10000>;
interrupts = <GIC_SPI 23 IRQ_TYPE_LEVEL_HIGH>;
+ interconnects = <&icc IMX8MQ_ICM_USDHC2 &icc IMX8MQ_ICS_DRAM>;
+ interconnect-names = "path";
+ fsl,icc-rate = <266666>;
clocks = <&clk IMX8MQ_CLK_IPG_ROOT>,
<&clk IMX8MQ_CLK_NAND_USDHC_BUS>,
<&clk IMX8MQ_CLK_USDHC2_ROOT>;
@@ -1272,6 +1278,9 @@ fec1: ethernet@30be0000 {
<GIC_SPI 119 IRQ_TYPE_LEVEL_HIGH>,
<GIC_SPI 120 IRQ_TYPE_LEVEL_HIGH>,
<GIC_SPI 121 IRQ_TYPE_LEVEL_HIGH>;
+ interconnects = <&icc IMX8MQ_ICM_ENET &icc IMX8MQ_ICS_DRAM>;
+ interconnect-names = "path";
+ fsl,icc-rate = <800000>;
clocks = <&clk IMX8MQ_CLK_ENET1_ROOT>,
<&clk IMX8MQ_CLK_ENET1_ROOT>,
<&clk IMX8MQ_CLK_ENET_TIMER>,
We add all the properties necessary to control the interconnect based on the required rates all the way from consumers to the dram. The fsl,icc-rate specifies the minimum required rate the consumer needs in order to operate. For now, only the fec, usdhc1 and usdhc2 are added as consumers. Signed-off-by: Abel Vesa <abel.vesa@nxp.com> --- arch/arm64/boot/dts/freescale/imx8mq.dtsi | 9 +++++++++ 1 file changed, 9 insertions(+)