@@ -3,7 +3,7 @@
#
# Common support
-obj-y := id.o io.o control.o mux.o devices.o serial.o gpmc.o timer-gp.o pm.o \
+obj-y := id.o io.o control.o mux.o devices.o serial.o gpmc.o timer.o pm.o \
common.o gpio.o dma.o wd_timer.o
omap-2-3-common = irq.o sdrc.o
similarity index 99%
rename from arch/arm/mach-omap2/timer-gp.c
rename to arch/arm/mach-omap2/timer.c
@@ -1,5 +1,5 @@
/*
- * linux/arch/arm/mach-omap2/timer-gp.c
+ * linux/arch/arm/mach-omap2/timer.c
*
* OMAP2 GP timer support.
*
@@ -230,7 +230,7 @@ static void __init omap2_gp_clockevent_init(int gptimer_id,
/* Clocksource code */
#ifdef CONFIG_OMAP_32K_TIMER
-/*
+/*
* When 32k-timer is enabled, don't use GPTimer for clocksource
* instead, just leave default clocksource which uses the 32k
* sync counter. See clocksource setup in plat-omap/counter_32k.c
We can keep everything sys_timer and gptimer.c related code in timer.c as the code will be very minimal. Later on we can also remove timer-mpu.c, as it can be called from omap4_timer_init function. This allows us to get rid of confusing existing files. We currently have timer-gp.c, timer-mpu.c, and patches have been posted to add dmtimer.c. There's no need to have these multiple files, we can put everything into timer.c. Signed-off-by: Tony Lindgren <tony@atomide.com> --- arch/arm/mach-omap2/Makefile | 2 +- arch/arm/mach-omap2/timer.c | 4 ++-- 2 files changed, 3 insertions(+), 3 deletions(-) rename arch/arm/mach-omap2/{timer-gp.c => timer.c} (99%)