@@ -365,6 +365,40 @@ static int amba_pm_restore_noirq(struct device *dev)
#endif /* !CONFIG_HIBERNATE_CALLBACKS */
+#ifdef CONFIG_PM_RUNTIME
+/*
+ * Hooks to provide runtime PM of the pclk (bus clock). It is safe to
+ * enable/disable the bus clock at runtime PM suspend/resume as this
+ * does not result in loss of context. However, disabling vcore power
+ * would do, so we leave that to the driver.
+ */
+static int amba_pm_runtime_suspend(struct device *dev)
+{
+ struct amba_device *pcdev = to_amba_device(dev);
+ int ret = pm_generic_runtime_suspend(dev);
+
+ if (ret == 0 && dev->driver)
+ clk_disable(pcdev->pclk);
+
+ return ret;
+}
+
+static int amba_pm_runtime_resume(struct device *dev)
+{
+ struct amba_device *pcdev = to_amba_device(dev);
+ int ret;
+
+ if (dev->driver) {
+ ret = clk_enable(pcdev->pclk);
+ /* Failure is probably fatal to the system, but... */
+ if (ret)
+ return ret;
+ }
+
+ return pm_generic_runtime_resume(dev);
+}
+#endif
+
#ifdef CONFIG_PM
static const struct dev_pm_ops amba_pm = {
@@ -383,8 +417,8 @@ static const struct dev_pm_ops amba_pm = {
.poweroff_noirq = amba_pm_poweroff_noirq,
.restore_noirq = amba_pm_restore_noirq,
SET_RUNTIME_PM_OPS(
- pm_generic_runtime_suspend,
- pm_generic_runtime_resume,
+ amba_pm_runtime_suspend,
+ amba_pm_runtime_resume,
pm_generic_runtime_idle
)
};
@@ -494,10 +528,18 @@ static int amba_probe(struct device *dev)
if (ret)
break;
+ pm_runtime_get_noresume(dev);
+ pm_runtime_set_active(dev);
+ pm_runtime_enable(dev);
+
ret = pcdrv->probe(pcdev, id);
if (ret == 0)
break;
+ pm_runtime_disable(dev);
+ pm_runtime_set_suspended(dev);
+ pm_runtime_put_noidle(dev);
+
amba_put_disable_pclk(pcdev);
amba_put_disable_vcore(pcdev);
} while (0);
@@ -509,7 +551,16 @@ static int amba_remove(struct device *dev)
{
struct amba_device *pcdev = to_amba_device(dev);
struct amba_driver *drv = to_amba_driver(dev->driver);
- int ret = drv->remove(pcdev);
+ int ret;
+
+ pm_runtime_get_sync(dev);
+ ret = drv->remove(pcdev);
+ pm_runtime_put_noidle(dev);
+
+ /* Undo the runtime PM settings in amba_probe() */
+ pm_runtime_disable(dev);
+ pm_runtime_set_suspended(dev);
+ pm_runtime_put_noidle(dev);
amba_put_disable_pclk(pcdev);
amba_put_disable_vcore(pcdev);
@@ -29,6 +29,7 @@
#include <linux/dmaengine.h>
#include <linux/dma-mapping.h>
#include <linux/amba/mmci.h>
+#include <linux/pm_runtime.h>
#include <asm/div64.h>
#include <asm/io.h>
@@ -170,6 +171,7 @@ mmci_request_end(struct mmci_host *host, struct mmc_request *mrq)
* back into the driver...
*/
spin_unlock(&host->lock);
+ pm_runtime_put(mmc_dev(host->mmc));
mmc_request_done(host->mmc, mrq);
spin_lock(&host->lock);
}
@@ -984,6 +986,8 @@ static void mmci_request(struct mmc_host *mmc, struct mmc_request *mrq)
return;
}
+ pm_runtime_get_sync(mmc_dev(mmc));
+
spin_lock_irqsave(&host->lock, flags);
host->mrq = mrq;
@@ -1327,6 +1331,8 @@ static int __devinit mmci_probe(struct amba_device *dev,
mmci_dma_setup(host);
+ pm_runtime_put(&dev->dev);
+
mmc_add_host(mmc);
return 0;
@@ -1364,6 +1370,12 @@ static int __devexit mmci_remove(struct amba_device *dev)
if (mmc) {
struct mmci_host *host = mmc_priv(mmc);
+ /*
+ * Undo pm_runtime_put() in probe. We use the _sync
+ * version here so that we can access the primecell.
+ */
+ pm_runtime_get_sync(&dev->dev);
+
mmc_remove_host(mmc);
writel(0, host->base + MMCIMASK0);
@@ -515,9 +515,6 @@ static void giveback(struct pl022 *pl022)
if (msg->complete)
msg->complete(msg->context);
/* This message is completed, so let's turn off the clocks & power */
- clk_disable(pl022->clk);
- amba_pclk_disable(pl022->adev);
- amba_vcore_disable(pl022->adev);
pm_runtime_put(&pl022->adev->dev);
}
@@ -1545,9 +1542,6 @@ static void pump_messages(struct work_struct *work)
* (poll/interrupt/DMA)
*/
pm_runtime_get_sync(&pl022->adev->dev);
- amba_vcore_enable(pl022->adev);
- amba_pclk_enable(pl022->adev);
- clk_enable(pl022->clk);
restore_state(pl022);
flush(pl022);
@@ -2186,8 +2180,6 @@ pl022_probe(struct amba_device *adev, const struct amba_id *id)
}
printk(KERN_INFO "pl022: mapped registers from 0x%08x to %p\n",
adev->res.start, pl022->virtbase);
- pm_runtime_enable(dev);
- pm_runtime_resume(dev);
pl022->clk = clk_get(&adev->dev, NULL);
if (IS_ERR(pl022->clk)) {
@@ -2195,7 +2187,6 @@ pl022_probe(struct amba_device *adev, const struct amba_id *id)
dev_err(&adev->dev, "could not retrieve SSP/SPI bus clock\n");
goto err_no_clk;
}
-
/* Disable SSP */
writew((readw(SSP_CR1(pl022->virtbase)) & (~SSP_CR1_MASK_SSE)),
SSP_CR1(pl022->virtbase));
@@ -2235,12 +2226,9 @@ pl022_probe(struct amba_device *adev, const struct amba_id *id)
goto err_spi_register;
}
dev_dbg(dev, "probe succeeded\n");
- /*
- * Disable the silicon block pclk and any voltage domain and just
- * power it up and clock it when it's needed
- */
- amba_pclk_disable(adev);
- amba_vcore_disable(adev);
+
+ /* let runtime pm put suspend */
+ pm_runtime_put(dev);
return 0;
err_spi_register:
@@ -2249,7 +2237,6 @@ pl022_probe(struct amba_device *adev, const struct amba_id *id)
destroy_queue(pl022);
pl022_dma_remove(pl022);
free_irq(adev->irq[0], pl022);
- pm_runtime_disable(&adev->dev);
err_no_irq:
clk_put(pl022->clk);
err_no_clk:
@@ -2271,6 +2258,12 @@ pl022_remove(struct amba_device *adev)
if (!pl022)
return 0;
+ /*
+ * undo pm_runtime_put() in probe. I assume that we're not
+ * accessing the primecell here.
+ */
+ pm_runtime_get_noresume(&adev->dev);
+
/* Remove the queue */
status = destroy_queue(pl022);
if (status != 0) {
@@ -2293,10 +2286,10 @@ pl022_remove(struct amba_device *adev)
return 0;
}
-#ifdef CONFIG_PM
-static int pl022_suspend(struct amba_device *adev, pm_message_t state)
+#ifdef CONFIG_SUSPEND
+static int pl011_suspend(struct device *dev)
{
- struct pl022 *pl022 = amba_get_drvdata(adev);
+ struct pl022 *pl022 = dev_get_drvdata(dev);
int status = 0;
status = stop_queue(pl022);
@@ -2305,34 +2298,58 @@ static int pl022_suspend(struct amba_device *adev, pm_message_t state)
return status;
}
- amba_vcore_enable(adev);
- amba_pclk_enable(adev);
+ amba_vcore_enable(pl022->adev);
+ amba_pclk_enable(pl022->adev);
load_ssp_default_config(pl022);
- amba_pclk_disable(adev);
- amba_vcore_disable(adev);
+ amba_pclk_disable(pl022->adev);
+ amba_vcore_disable(pl022->adev);
dev_dbg(&adev->dev, "suspended\n");
return 0;
}
-static int pl022_resume(struct amba_device *adev)
+static int pl022_resume(struct device *dev)
{
- struct pl022 *pl022 = amba_get_drvdata(adev);
+ struct pl022 *pl022 = dev_get_drvdata(dev);
int status = 0;
/* Start the queue running */
status = start_queue(pl022);
if (status)
- dev_err(&adev->dev, "problem starting queue (%d)\n", status);
+ dev_err(dev, "problem starting queue (%d)\n", status);
else
- dev_dbg(&adev->dev, "resumed\n");
+ dev_dbg(dev, "resumed\n");
return status;
}
-#else
-#define pl022_suspend NULL
-#define pl022_resume NULL
#endif /* CONFIG_PM */
+#ifdef CONFIG_PM_RUNTIME
+static int pl022_runtime_suspend(struct device *dev)
+{
+ struct pl022 *pl022 = dev_get_drvdata(dev);
+
+ clk_disable(pl022->clk);
+ amba_vcore_disable(pl022->adev);
+
+ return 0;
+}
+
+static int pl022_runtime_resume(struct device *dev)
+{
+ struct pl022 *pl022 = dev_get_drvdata(dev);
+
+ amba_vcore_enable(pl022->adev);
+ clk_enable(pl022->clk);
+
+ return 0;
+}
+#endif
+
+static const struct dev_pm_ops pl022_dev_pm_ops = {
+ SET_SYSTEM_SLEEP_PM_OPS(pl022_suspend, pl022_resume)
+ SET_RUNTIME_PM_OPS(pl022_runtime_suspend, pl022_runtime_resume, NULL)
+};
+
static struct vendor_data vendor_arm = {
.fifodepth = 8,
.max_bpw = 16,
@@ -2412,12 +2429,11 @@ static struct amba_id pl022_ids[] = {
static struct amba_driver pl022_driver = {
.drv = {
.name = "ssp-pl022",
+ .pm = &pl022_dev_pm_ops,
},
.id_table = pl022_ids,
.probe = pl022_probe,
.remove = __devexit_p(pl022_remove),
- .suspend = pl022_suspend,
- .resume = pl022_resume,
};