@@ -614,16 +614,16 @@ static struct omap_mux __initdata omap3_muxmodes[] = {
"sys_off_mode", NULL, NULL, NULL,
"gpio_9", NULL, NULL, "safe_mode"),
_OMAP3_MUXENTRY(UART1_CTS, 150,
- "uart1_cts", NULL, NULL, NULL,
+ "uart1_cts", "ssi1_rdy_tx", NULL, NULL,
"gpio_150", "hsusb3_tll_clk", NULL, "safe_mode"),
_OMAP3_MUXENTRY(UART1_RTS, 149,
- "uart1_rts", NULL, NULL, NULL,
+ "uart1_rts", "ssi1_flag_tx", NULL, NULL,
"gpio_149", NULL, NULL, "safe_mode"),
_OMAP3_MUXENTRY(UART1_RX, 151,
- "uart1_rx", NULL, "mcbsp1_clkr", "mcspi4_clk",
+ "uart1_rx", "ss1_wake_tx", "mcbsp1_clkr", "mcspi4_clk",
"gpio_151", NULL, NULL, "safe_mode"),
_OMAP3_MUXENTRY(UART1_TX, 148,
- "uart1_tx", NULL, NULL, NULL,
+ "uart1_tx", "ssi1_dat_tx", NULL, NULL,
"gpio_148", NULL, NULL, "safe_mode"),
_OMAP3_MUXENTRY(UART2_CTS, 144,
"uart2_cts", "mcbsp3_dx", "gpt9_pwm_evt", NULL,
On n900 uart1 pins are not not used for uart, instead they are used to connect to a cell modem over ssi. Looks like we're currently missing these signal names for 3430 for some reason, and only have some of them listed for 3630. Obviously the signals are there for 3430 if n900 is using them and they are documented in some TRMs. Note that these will eventually be replaced by device tree based pinctrl-single.c driver. But for now these are needed to verify the SSI pins for devices like Nokia N900. Signed-off-by: Tony Lindgren <tony@atomide.com> --- 0 files changed