diff mbox

[v5,5/9] ARM64: dts: meson-gxbb-wetek-hub: add the ethernet PHY's reset GPIO

Message ID 20170219214149.30418-6-martin.blumenstingl@googlemail.com (mailing list archive)
State New, archived
Headers show

Commit Message

Martin Blumenstingl Feb. 19, 2017, 9:41 p.m. UTC
This resets the ethernet PHY during boot to get the PHY into a "clean"
state.
While here also specify the phy-handle of the ethmac node to make the
PHY configuration similar to the one we have on GXL devices. This will
allow us to specify OF-properties for the PHY itself.

Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
---
 .../boot/dts/amlogic/meson-gxbb-wetek-hub.dts      | 24 ++++++++++++++++++++++
 1 file changed, 24 insertions(+)
diff mbox

Patch

diff --git a/arch/arm64/boot/dts/amlogic/meson-gxbb-wetek-hub.dts b/arch/arm64/boot/dts/amlogic/meson-gxbb-wetek-hub.dts
index 56f855901262..50eb8f06d35b 100644
--- a/arch/arm64/boot/dts/amlogic/meson-gxbb-wetek-hub.dts
+++ b/arch/arm64/boot/dts/amlogic/meson-gxbb-wetek-hub.dts
@@ -64,3 +64,27 @@ 
 		status = "disabled";
 	};
 };
+
+&ethmac {
+	status = "okay";
+	pinctrl-0 = <&eth_rgmii_pins>;
+	pinctrl-names = "default";
+
+	phy-handle = <&eth_phy0>;
+	phy-mode = "rgmii";
+
+	snps,reset-gpio = <&gpio GPIOZ_14 0>;
+	snps,reset-delays-us = <0 10000 1000000>;
+	snps,reset-active-low;
+
+	mdio {
+		compatible = "snps,dwmac-mdio";
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		eth_phy0: ethernet-phy@0 {
+			/* Realtek RTL8211F (0x001cc916) */
+			reg = <0>;
+		};
+	};
+};