@@ -206,6 +206,19 @@
#size-cells = <0>;
};
+ usb_otg: usb@01c19000 {
+ compatible = "allwinner,sun8i-h3-musb";
+ reg = <0x01c19000 0x0400>;
+ clocks = <&ccu CLK_BUS_OTG>;
+ resets = <&ccu RST_BUS_OTG>;
+ interrupts = <GIC_SPI 71 IRQ_TYPE_LEVEL_HIGH>;
+ interrupt-names = "mc";
+ phys = <&usbphy 0>;
+ phy-names = "usb";
+ extcon = <&usbphy 0>;
+ status = "disabled";
+ };
+
usbphy: phy@01c19400 {
compatible = "allwinner,sun8i-h3-usb-phy";
reg = <0x01c19400 0x2c>,
@@ -238,6 +251,25 @@
#phy-cells = <1>;
};
+ ehci0: usb@01c1a000 {
+ compatible = "allwinner,sun8i-h3-ehci", "generic-ehci";
+ reg = <0x01c1a000 0x100>;
+ interrupts = <GIC_SPI 72 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&ccu CLK_BUS_EHCI0>, <&ccu CLK_BUS_OHCI0>;
+ resets = <&ccu RST_BUS_EHCI0>, <&ccu RST_BUS_OHCI0>;
+ status = "disabled";
+ };
+
+ ohci0: usb@01c1a400 {
+ compatible = "allwinner,sun8i-h3-ohci", "generic-ohci";
+ reg = <0x01c1a400 0x100>;
+ interrupts = <GIC_SPI 73 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&ccu CLK_BUS_EHCI0>, <&ccu CLK_BUS_OHCI0>,
+ <&ccu CLK_USB_OHCI0>;
+ resets = <&ccu RST_BUS_EHCI0>, <&ccu RST_BUS_OHCI0>;
+ status = "disabled";
+ };
+
ehci1: usb@01c1b000 {
compatible = "allwinner,sun8i-h3-ehci", "generic-ehci";
reg = <0x01c1b000 0x100>;
Allwinner H3 have a dual-routed USB PHY0 -- routed to either OHCI/EHCI or MUSB controller. Add device nodes for these controllers. Signed-off-by: Icenowy Zheng <icenowy@aosc.xyz> --- Changes in v2: - Unbind PHY from *HCI controllers, as they do not know how to properly handle the Vbus status. arch/arm/boot/dts/sun8i-h3.dtsi | 32 ++++++++++++++++++++++++++++++++ 1 file changed, 32 insertions(+)