@@ -17,8 +17,6 @@
* <mux_reg conf_reg input_reg mux_mode input_val>
*/
-#define MX25_PAD_TDO__TDO 0x000 0x3e8 0x000 0x00 0x000
-
#define MX25_PAD_A10__A10 0x008 0x000 0x000 0x00 0x000
#define MX25_PAD_A10__GPIO_4_0 0x008 0x000 0x000 0x05 0x000
@@ -541,6 +539,8 @@
#define MX25_PAD_RTCK__OWIRE 0x1ec 0x3e4 0x000 0x01 0x000
#define MX25_PAD_RTCK__GPIO_3_14 0x1ec 0x3e4 0x000 0x05 0x000
+#define MX25_PAD_TDO__TDO 0x000 0x3e8 0x000 0x00 0x000
+
#define MX25_PAD_DE_B__DE_B 0x1f0 0x3ec 0x000 0x00 0x000
#define MX25_PAD_DE_B__GPIO_2_20 0x1f0 0x3ec 0x000 0x05 0x000
The pinfunc definitions are ordered by mux_reg and so automatically by conf_reg, too. PAD_TDO is the only pad that has a conf_reg but no mux_reg. Put it to the place where it its in the order of conf_regs instead of the top. Signed-off-by: Uwe Kleine-König <uwe@kleine-koenig.org> --- arch/arm/boot/dts/imx25-pinfunc.h | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)