@@ -162,7 +162,7 @@
#size-cells = <1>;
ranges;
- pio: pinctrl@01c20800 {
+ pio: pinctrl@1c20800 {
compatible = "allwinner,sun8i-a83t-pinctrl";
interrupts = <GIC_SPI 15 IRQ_TYPE_LEVEL_HIGH>,
<GIC_SPI 17 IRQ_TYPE_LEVEL_HIGH>,
@@ -193,7 +193,7 @@
};
};
- timer@01c20c00 {
+ timer@1c20c00 {
compatible = "allwinner,sun4i-a10-timer";
reg = <0x01c20c00 0xa0>;
interrupts = <GIC_SPI 18 IRQ_TYPE_LEVEL_HIGH>,
@@ -201,7 +201,7 @@
clocks = <&osc24M>;
};
- watchdog@01c20ca0 {
+ watchdog@1c20ca0 {
compatible = "allwinner,sun6i-a31-wdt";
reg = <0x01c20ca0 0x20>;
interrupts = <GIC_SPI 25 IRQ_TYPE_LEVEL_HIGH>;
@@ -218,7 +218,7 @@
status = "disabled";
};
- gic: interrupt-controller@01c81000 {
+ gic: interrupt-controller@1c81000 {
compatible = "arm,cortex-a7-gic", "arm,cortex-a15-gic";
reg = <0x01c81000 0x1000>,
<0x01c82000 0x2000>,
Kbuild now complains about leading zeroes in the address portion of device node names. Get rid of them all, except for the uart device node. U-boot currently hard codes the device node path. We can remove the leading zero for the uart once we teach U-boot to use the aliases or stdout-path property. Signed-off-by: Chen-Yu Tsai <wens@csie.org> --- arch/arm/boot/dts/sun8i-a83t.dtsi | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-)