@@ -18,6 +18,7 @@
#include <linux/inetdevice.h>
#include <linux/mbus.h>
#include <linux/module.h>
+#include <linux/mfd/syscon.h>
#include <linux/interrupt.h>
#include <linux/cpumask.h>
#include <linux/of.h>
@@ -30,6 +31,7 @@
#include <linux/clk.h>
#include <linux/hrtimer.h>
#include <linux/ktime.h>
+#include <linux/regmap.h>
#include <uapi/linux/ppp_defs.h>
#include <net/ip.h>
#include <net/ipv6.h>
@@ -381,6 +383,38 @@
#define MVPP2_QUEUE_NEXT_DESC(q, index) \
(((index) < (q)->last_desc) ? ((index) + 1) : 0)
+/* XPCS registers. PPv2.2 only */
+#define MVPP22_MPCS_BASE(port) (0x7000 + (port) * 0x1000)
+#define MVPP22_MPCS_CTRL 0x14
+#define MVPP22_MPCS_CTRL_FWD_ERR_CONN BIT(10)
+#define MVPP22_MPCS_CLK_RESET 0x14c
+#define MAC_CLK_RESET_SD_TX BIT(0)
+#define MAC_CLK_RESET_SD_RX BIT(1)
+#define MAC_CLK_RESET_MAC BIT(2)
+#define MVPP22_MPCS_CLK_RESET_DIV_RATIO(n) ((n) << 4)
+#define MVPP22_MPCS_CLK_RESET_DIV_SET BIT(11)
+
+/* XPCS registers. PPv2.2 only */
+#define MVPP22_XPCS_BASE(port) (0x7400 + (port) * 0x1000)
+#define MVPP22_XPCS_CFG0 0x0
+#define MVPP22_XPCS_CFG0_PCS_MODE(n) ((n) << 3)
+#define MVPP22_XPCS_CFG0_ACTIVE_LANE(n) ((n) << 5)
+
+/* System controller registers. Accessed through a regmap. */
+#define GENCONF_SOFT_RESET1 0x1108
+#define GENCONF_SOFT_RESET1_GOP BIT(6)
+#define GENCONF_PORT_CTRL0 0x1110
+#define GENCONF_PORT_CTRL0_BUS_WIDTH_SELECT BIT(1)
+#define GENCONF_PORT_CTRL0_RX_DATA_SAMPLE BIT(29)
+#define GENCONF_PORT_CTRL0_CLK_DIV_PHASE_CLR BIT(31)
+#define GENCONF_PORT_CTRL1 0x1114
+#define GENCONF_PORT_CTRL1_EN(p) BIT(p)
+#define GENCONF_PORT_CTRL1_RESET(p) (BIT(p) << 28)
+#define GENCONF_CTRL0 0x1120
+#define GENCONF_CTRL0_PORT0_RGMII BIT(0)
+#define GENCONF_CTRL0_PORT1_RGMII_MII BIT(1)
+#define GENCONF_CTRL0_PORT1_RGMII BIT(2)
+
/* Various constants */
/* Coalescing */
@@ -721,6 +755,11 @@ struct mvpp2 {
*/
void __iomem *cpu_base[MVPP2_MAX_CPUS];
+ /* On PPv2.2, some port control registers are located into the system
+ * controller space. These registers are accessible through a regmap.
+ */
+ struct regmap *sysctrl_base;
+
/* Common clocks */
struct clk *pp_clk;
struct clk *gop_clk;
@@ -4185,6 +4224,112 @@ static void mvpp2_interrupts_unmask(void *arg)
/* Port configuration routines */
+static void mvpp22_gop_init_rgmii(struct mvpp2_port *port)
+{
+ struct mvpp2 *priv = port->priv;
+ u32 val;
+
+ regmap_read(priv->sysctrl_base, GENCONF_CTRL0, &val);
+ val |= GENCONF_CTRL0_PORT1_RGMII;
+ regmap_write(priv->sysctrl_base, GENCONF_CTRL0, val);
+}
+
+static void mvpp22_gop_init_sgmii(struct mvpp2_port *port)
+{
+ struct mvpp2 *priv = port->priv;
+ u32 val;
+
+ regmap_read(priv->sysctrl_base, GENCONF_PORT_CTRL0, &val);
+ val |= GENCONF_PORT_CTRL0_BUS_WIDTH_SELECT |
+ GENCONF_PORT_CTRL0_RX_DATA_SAMPLE;
+ regmap_write(priv->sysctrl_base, GENCONF_PORT_CTRL0, val);
+
+ if (port->gop_id > 1) {
+ regmap_read(priv->sysctrl_base, GENCONF_CTRL0, &val);
+ if (port->gop_id == 2)
+ val &= ~GENCONF_CTRL0_PORT0_RGMII;
+ else if (port->gop_id == 3)
+ val &= ~GENCONF_CTRL0_PORT1_RGMII_MII;
+ regmap_write(priv->sysctrl_base, GENCONF_CTRL0, val);
+ }
+}
+
+static void mvpp22_gop_init_10gkr(struct mvpp2_port *port)
+{
+ struct mvpp2 *priv = port->priv;
+ void __iomem *mpcs = priv->iface_base + MVPP22_MPCS_BASE(port->gop_id);
+ void __iomem *xpcs = priv->iface_base + MVPP22_XPCS_BASE(port->gop_id);
+ u32 val;
+
+ /* XPCS */
+ val = readl(xpcs + MVPP22_XPCS_CFG0);
+ val &= ~(MVPP22_XPCS_CFG0_PCS_MODE(0x3) |
+ MVPP22_XPCS_CFG0_ACTIVE_LANE(0x3));
+ val |= MVPP22_XPCS_CFG0_ACTIVE_LANE(2);
+ writel(val, xpcs + MVPP22_XPCS_CFG0);
+
+ /* MPCS */
+ val = readl(mpcs + MVPP22_MPCS_CTRL);
+ val &= ~MVPP22_MPCS_CTRL_FWD_ERR_CONN;
+ writel(val, mpcs + MVPP22_MPCS_CTRL);
+
+ val = readl(mpcs + MVPP22_MPCS_CLK_RESET);
+ val &= ~(MVPP22_MPCS_CLK_RESET_DIV_RATIO(0x7) | MAC_CLK_RESET_MAC |
+ MAC_CLK_RESET_SD_RX | MAC_CLK_RESET_SD_TX);
+ val |= MVPP22_MPCS_CLK_RESET_DIV_RATIO(1);
+ writel(val, mpcs + MVPP22_MPCS_CLK_RESET);
+
+ val &= ~MVPP22_MPCS_CLK_RESET_DIV_SET;
+ val |= MAC_CLK_RESET_MAC | MAC_CLK_RESET_SD_RX | MAC_CLK_RESET_SD_TX;
+ writel(val, mpcs + MVPP22_MPCS_CLK_RESET);
+}
+
+static int mvpp22_gop_init(struct mvpp2_port *port)
+{
+ struct mvpp2 *priv = port->priv;
+ u32 val;
+
+ if (!priv->sysctrl_base)
+ return 0;
+
+ switch (port->phy_interface) {
+ case PHY_INTERFACE_MODE_RGMII:
+ if (port->gop_id != 3)
+ goto invalid_conf;
+ mvpp22_gop_init_rgmii(port);
+ case PHY_INTERFACE_MODE_SGMII:
+ mvpp22_gop_init_sgmii(port);
+ break;
+ case PHY_INTERFACE_MODE_10GKR:
+ if (port->gop_id != 0)
+ goto invalid_conf;
+ mvpp22_gop_init_10gkr(port);
+ break;
+ default:
+ goto unsupported_conf;
+ }
+
+ regmap_read(priv->sysctrl_base, GENCONF_PORT_CTRL1, &val);
+ val |= GENCONF_PORT_CTRL1_RESET(port->gop_id);
+ val |= GENCONF_PORT_CTRL1_EN(port->gop_id);
+ regmap_write(priv->sysctrl_base, GENCONF_PORT_CTRL1, val);
+
+ regmap_read(priv->sysctrl_base, GENCONF_PORT_CTRL0, &val);
+ val |= GENCONF_PORT_CTRL0_CLK_DIV_PHASE_CLR;
+ regmap_write(priv->sysctrl_base, GENCONF_PORT_CTRL0, val);
+
+ regmap_read(priv->sysctrl_base, GENCONF_SOFT_RESET1, &val);
+ val |= GENCONF_SOFT_RESET1_GOP;
+ regmap_write(priv->sysctrl_base, GENCONF_SOFT_RESET1, val);
+
+unsupported_conf:
+ return 0;
+
+invalid_conf:
+ netdev_err(port->dev, "Invalid port configuration\n");
+ return -EINVAL;
+}
+
static void mvpp2_port_mii_gmac_configure_mode(struct mvpp2_port *port)
{
u32 val;
@@ -5944,6 +6089,9 @@ static void mvpp2_start_dev(struct mvpp2_port *port)
/* Enable interrupts on all CPUs */
mvpp2_interrupts_enable(port);
+ if (port->priv->hw_version == MVPP22)
+ mvpp22_gop_init(port);
+
mvpp2_port_mii_set(port);
mvpp2_port_enable(port);
phy_start(ndev->phydev);
@@ -7013,6 +7161,17 @@ static int mvpp2_probe(struct platform_device *pdev)
priv->iface_base = devm_ioremap_resource(&pdev->dev, res);
if (IS_ERR(priv->iface_base))
return PTR_ERR(priv->iface_base);
+
+ priv->sysctrl_base =
+ syscon_regmap_lookup_by_phandle(pdev->dev.of_node,
+ "marvell,system-controller");
+ if (IS_ERR(priv->sysctrl_base))
+ /* The system controller regmap is optional for dt
+ * compatibility reasons. When not provided, the
+ * configuration of the GoP relies on the
+ * firmware/bootloader.
+ */
+ priv->sysctrl_base = NULL;
}
for_each_present_cpu(cpu) {
The patch adds GoP (group of ports) initialization functions. The mvpp2 driver was relying on the firmware/bootloader initialization; this patch moves this setup to the mvpp2 driver. Signed-off-by: Antoine Tenart <antoine.tenart@free-electrons.com> --- drivers/net/ethernet/marvell/mvpp2.c | 159 +++++++++++++++++++++++++++++++++++ 1 file changed, 159 insertions(+)