[14/14] mmc: meson-gx: implement voltage switch callback

Commit Message

Jerome Brunet Aug. 4, 2017, 5:43 p.m. UTC

Implement voltage switch callback (shamelessly copied from sunxi mmc
driver). This allow, with the appropriate tuning function, to use
SD ultra high speed modes.

Signed-off-by: Jerome Brunet <[e-mail]>
---
 drivers/mmc/host/meson-gx-mmc.c | 25 +++++++++++++++++++++++++
 1 file changed, 25 insertions(+)

Patch

diff --git a/drivers/mmc/host/meson-gx-mmc.c b/drivers/mmc/host/meson-gx-mmc.c
index e991c9e452ab..de2d7b8a9d97 100644
--- a/drivers/mmc/host/meson-gx-mmc.c
+++ b/drivers/mmc/host/meson-gx-mmc.c
@@ -38,6 +38,8 @@ 
 #include <linux/interrupt.h>
 #include <linux/bitfield.h>
 
+#include <linux/delay.h>
+
 #define DRIVER_NAME "meson-gx-mmc"
 
 #define SD_EMMC_CLOCK 0x0
@@ -1024,6 +1026,28 @@  static int meson_mmc_card_busy(struct mmc_host *mmc)
 	return !(FIELD_GET(STATUS_DATI, regval) & 0xf);
 }
 
+static int meson_mmc_voltage_switch(struct mmc_host *mmc, struct mmc_ios *ios)
+{
+	/* vqmmc regulator is available */
+	if (!IS_ERR(mmc->supply.vqmmc)) {
+		/*
+		 * The usual amlogic setup uses a GPIO to switch from one
+		 * regulator to the other. While the voltage ramp up is
+		 * pretty fast, care must be taken when switching from 3.3v
+		 * to 1.8v. Please make sure the regulator framework is aware
+		 * of your own regulator constraints
+		 */
+		return mmc_regulator_set_vqmmc(mmc, ios);
+
+	}
+
+	/* no vqmmc regulator, assume fixed regulator at 3/3.3V */
+	if (ios->signal_voltage == MMC_SIGNAL_VOLTAGE_330)
+		return 0;
+
+	return -EINVAL;
+}
+
 static const struct mmc_host_ops meson_mmc_ops = {
 	.request	= meson_mmc_request,
 	.set_ios	= meson_mmc_set_ios,
@@ -1032,6 +1056,7 @@  static const struct mmc_host_ops meson_mmc_ops = {
 	.post_req	= meson_mmc_post_req,
 	.execute_tuning = meson_mmc_execute_tuning,
 	.card_busy	= meson_mmc_card_busy,
+	.start_signal_voltage_switch = meson_mmc_voltage_switch,
 };
 
 static int meson_mmc_probe(struct platform_device *pdev)