| Message ID | 20171018130628.11298-4-icenowy@aosc.io (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
diff --git a/arch/arm/boot/dts/sun8i-v40-bananapi-m2-berry.dts b/arch/arm/boot/dts/sun8i-v40-bananapi-m2-berry.dts index 8a69be2a0842..fe16fc0eb518 100644 --- a/arch/arm/boot/dts/sun8i-v40-bananapi-m2-berry.dts +++ b/arch/arm/boot/dts/sun8i-v40-bananapi-m2-berry.dts @@ -72,6 +72,15 @@ }; }; + reg_vcc5v0: vcc5v0 { + compatible = "regulator-fixed"; + regulator-name = "vcc5v0"; + regulator-min-microvolt = <5000000>; + regulator-max-microvolt = <5000000>; + gpio = <&pio 7 23 GPIO_ACTIVE_HIGH>; /* PH23 */ + enable-active-high; + }; + wifi_pwrseq: wifi_pwrseq { compatible = "mmc-pwrseq-simple"; reset-gpios = <&pio 6 10 GPIO_ACTIVE_LOW>; /* PG10 WIFI_EN */
On the Banana Pi M2 Berry board, the 5V power output (used by HDMI, SATA and USB) is controlled via a GPIO. Add regulator node for it. Signed-off-by: Icenowy Zheng <icenowy@aosc.io> --- arch/arm/boot/dts/sun8i-v40-bananapi-m2-berry.dts | 9 +++++++++ 1 file changed, 9 insertions(+)