diff mbox

[19/27] dt-bindings: cp110: add the thermal node in the syscon file

Message ID 20180421151255.29929-20-miquel.raynal@bootlin.com
State New, archived
Headers show

Commit Message

Miquel Raynal April 21, 2018, 3:12 p.m. UTC
Explain the thermal bindings now that the thermal IP is described being
inside of a system controller. Add a reference to the thermal-zone node.

Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
---
 .../arm/marvell/cp110-system-controller.txt        | 42 ++++++++++++++++++++++
 1 file changed, 42 insertions(+)
diff mbox

Patch

diff --git a/Documentation/devicetree/bindings/arm/marvell/cp110-system-controller.txt b/Documentation/devicetree/bindings/arm/marvell/cp110-system-controller.txt
index 54b0d64ce819..e372c21d2a57 100644
--- a/Documentation/devicetree/bindings/arm/marvell/cp110-system-controller.txt
+++ b/Documentation/devicetree/bindings/arm/marvell/cp110-system-controller.txt
@@ -11,6 +11,9 @@  For the top level node:
  - compatible: must be: "syscon", "simple-mfd";
  - reg: register area of the CP110 system controller
 
+SYSTEM CONTROLLER 0
+===================
+
 Clocks:
 -------
 
@@ -186,3 +189,42 @@  CP110_LABEL(syscon0): system-controller@440000 {
 	};
 
 };
+
+SYSTEM CONTROLLER 1
+===================
+
+Thermal:
+--------
+
+The thermal IP can probe the temperature all around the processor. It
+may feature several channels, each of them wired to one sensor.
+
+It is possible to setup an overheat interrupt by giving at least one
+critical point to any subnode of the thermal-zone node.
+
+For common binding part and usage, refer to
+Documentation/devicetree/bindings/thermal/thermal.txt
+
+Required properties:
+- compatible: "marvell,armada-cp110-thermal"
+
+Optional properties:
+- interrupt-parent/interrupts: overheat interrupt handle. Should point to
+  line 37 of the SEI irqchip (shared between CPs).
+  See interrupt-controller/interrupts.txt
+- #thermal-sensor-cells: shall be <1> when thermal-zones subnodes refer
+  to this IP and represents the channel ID. There is one sensor per
+  channel. O refers to the thermal IP internal channel.
+
+Example:
+CP110_LABEL(syscon1): system-controller@6f8000 {
+	compatible = "syscon", "simple-mfd";
+	reg = <0x6f8000 0x1000>;
+
+	CP110_LABEL(thermal): ap-thermal {
+		compatible = "marvell,armada-cp110-thermal";
+		interrupt-parent = <&sei>;
+		interrupts = <37>;
+		#thermal-sensor-cells = <1>;
+	};
+};