@@ -114,6 +114,41 @@
#include "axp22x.dtsi"
+&mmc0 {
+ vmmc-supply = <®_dcdc1>;
+ bus-width = <4>;
+ cd-gpios = <&pio 7 13 GPIO_ACTIVE_HIGH>; /* PH13 */
+ cd-inverted;
+ status = "okay";
+};
+
+&mmc1 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&mmc1_pg_pins>;
+ vmmc-supply = <®_dldo2>;
+ vqmmc-supply = <®_dldo1>;
+ mmc-pwrseq = <&wifi_pwrseq>;
+ bus-width = <4>;
+ non-removable;
+ status = "okay";
+};
+
+&mmc2 {
+ vmmc-supply = <®_dcdc1>;
+ vqmmc-supply = <®_dcdc1>;
+ bus-width = <8>;
+ non-removable;
+ status = "okay";
+};
+
+&ohci1 {
+ status = "okay";
+};
+
+&ohci2 {
+ status = "okay";
+};
+
®_aldo3 {
regulator-always-on;
regulator-min-microvolt = <2700000>;
@@ -161,40 +196,6 @@
regulator-name = "vcc-wifi";
};
-&mmc0 {
- vmmc-supply = <®_dcdc1>;
- bus-width = <4>;
- cd-gpios = <&pio 7 13 GPIO_ACTIVE_LOW>; /* PH13 */
- status = "okay";
-};
-
-&mmc1 {
- pinctrl-names = "default";
- pinctrl-0 = <&mmc1_pg_pins>;
- vmmc-supply = <®_dldo2>;
- vqmmc-supply = <®_dldo1>;
- mmc-pwrseq = <&wifi_pwrseq>;
- bus-width = <4>;
- non-removable;
- status = "okay";
-};
-
-&mmc2 {
- vmmc-supply = <®_dcdc1>;
- vqmmc-supply = <®_dcdc1>;
- bus-width = <8>;
- non-removable;
- status = "okay";
-};
-
-&ohci1 {
- status = "okay";
-};
-
-&ohci2 {
- status = "okay";
-};
-
&uart0 {
pinctrl-names = "default";
pinctrl-0 = <&uart0_pb_pins>;
The device nodes dereference (&foo) usages should be sorted by the label names, barring any parsing order issues such as the #include statement for the PMIC's .dtsi file that must come after the PMIC. Move the mmc and ohci blocks in front of the PMIC's regulator blocks. Signed-off-by: Chen-Yu Tsai <wens@csie.org> --- .../boot/dts/sun8i-r40-bananapi-m2-ultra.dts | 69 ++++++++++--------- 1 file changed, 35 insertions(+), 34 deletions(-)