@@ -345,7 +345,8 @@ dtb-$(CONFIG_SOC_IMX27) += \
imx27-phytec-phycore-rdk.dtb \
imx27-phytec-phycard-s-rdk.dtb
dtb-$(CONFIG_SOC_IMX31) += \
- imx31-bug.dtb
+ imx31-bug.dtb \
+ imx31-lite.dtb
dtb-$(CONFIG_SOC_IMX35) += \
imx35-eukrea-mbimxsd35-baseboard.dtb \
imx35-pdk.dtb
new file mode 100644
@@ -0,0 +1,177 @@
+// SPDX-License-Identifier: GPL-2.0+
+//
+// Copyright (C) 2016-2018 Vladimir Zapolskiy <vz@mleia.com>
+
+/dts-v1/;
+
+#include "imx31.dtsi"
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/interrupt-controller/irq.h>
+
+/ {
+ model = "LogicPD i.MX31 Lite";
+ compatible = "logicpd,imx31-lite", "fsl,imx31";
+
+ chosen {
+ stdout-path = &uart1;
+ };
+
+ memory@80000000 {
+ reg = <0x80000000 0x8000000>;
+ };
+
+ leds {
+ compatible = "gpio-leds";
+
+ led0 {
+ gpios = <&gpio1 8 GPIO_ACTIVE_LOW>;
+ };
+
+ led1 {
+ gpios = <&gpio1 7 GPIO_ACTIVE_LOW>;
+ };
+ };
+};
+
+&ata {
+ status = "okay";
+};
+
+&nfc {
+ nand-bus-width = <8>;
+ nand-ecc-mode = "hw";
+ nand-on-flash-bbt;
+ status = "okay";
+};
+
+&sdhci1 {
+ bus-width = <4>;
+ cd-gpios = <&gpio2 11 GPIO_ACTIVE_HIGH>;
+ wp-gpios = <&gpio1 6 GPIO_ACTIVE_HIGH>;
+ status = "okay";
+};
+
+&spi2 {
+ status = "okay";
+
+ pmic@0 {
+ compatible = "fsl,mc13783";
+ reg = <0>;
+ spi-cs-high;
+ spi-max-frequency = <1000000>;
+ interrupt-parent = <&gpio1>;
+ interrupts = <3 IRQ_TYPE_EDGE_RISING>;
+
+ fsl,mc13xxx-uses-adc;
+ fsl,mc13xxx-uses-rtc;
+
+ regulators {
+ sw1a { /* QVCC */
+ regulator-min-microvolt = <1200000>;
+ regulator-max-microvolt = <1500000>;
+ regulator-always-on;
+ regulator-boot-on;
+ };
+
+ sw1b { /* QVCC */
+ regulator-min-microvolt = <1200000>;
+ regulator-max-microvolt = <1500000>;
+ regulator-always-on;
+ regulator-boot-on;
+ };
+
+ sw2a { /* 1.8V_DDR, NVCC2, NVCC21 and NVCC22 */
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <1800000>;
+ regulator-always-on;
+ regulator-boot-on;
+ };
+
+ sw2b { /* NVCC10 */
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <1800000>;
+ regulator-always-on;
+ regulator-boot-on;
+ };
+
+ violo { /* NVCC1 and NVCC7 */
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <1800000>;
+ regulator-always-on;
+ regulator-boot-on;
+ };
+
+ viohi { /* VIOHI */
+ regulator-min-microvolt = <2775000>;
+ regulator-max-microvolt = <2775000>;
+ regulator-always-on;
+ regulator-boot-on;
+ };
+
+ vaudio { /* VAUDIO */
+ regulator-min-microvolt = <2775000>;
+ regulator-max-microvolt = <2775000>;
+ };
+
+ vcam { /* NVCC4 */
+ regulator-min-microvolt = <2800000>;
+ regulator-max-microvolt = <2800000>;
+ };
+
+ vgen { /* NVCC5 / NVCC8 and NVCC6 / NVCC9 */
+ regulator-min-microvolt = <2775000>;
+ regulator-max-microvolt = <2775000>;
+ regulator-always-on;
+ regulator-boot-on;
+ };
+
+ vmmc2 { /* NVCC3 */
+ regulator-min-microvolt = <1600000>;
+ regulator-max-microvolt = <3000000>;
+ regulator-always-on;
+ regulator-boot-on;
+ };
+ };
+ };
+};
+
+&uart1 {
+ uart-has-rtscts;
+ status = "okay";
+};
+
+/* Routed to the extension board */
+&uart2 {
+ uart-has-rtscts;
+ status = "okay";
+};
+
+/* Routed to the extension board */
+&uart3 {
+ uart-has-rtscts;
+ status = "okay";
+};
+
+&weim {
+ status = "okay";
+
+ nor@0,0 {
+ compatible = "cfi-flash";
+ reg = <0 0x0 0x200000>;
+ bank-width = <2>;
+ linux,mtd-name = "physmap-flash.0";
+ fsl,weim-cs-timing = <0x0000cf03 0xa0330d01 0x00220800>;
+ };
+
+ ethernet@4,0 {
+ compatible = "smsc,lan9117", "smsc,lan9115";
+ reg = <4 0x0 0x100>;
+ interrupt-parent = <&gpio1>;
+ interrupts = <26 IRQ_TYPE_EDGE_FALLING>;
+ phy-mode = "mii";
+ reg-io-width = <2>;
+ smsc,irq-push-pull;
+ fsl,weim-cs-timing = <0x00008701 0x04000541 0x00010000>;
+ };
+};
The added DTS contains a combined description of LogicPD MX31 Lite SoM devices, peripherals are routed to ports on a baseboard: * PATA controller, * SD/MMC controller, * 2 GPIO LEDs, * UART controllers, * Freescale MC13783 MFD connected over SPI, * SMSC LAN9117, * ST Micro NAND SLC, 64 MiB, * Intel NOR flash, 16 MiB. Signed-off-by: Vladimir Zapolskiy <vz@mleia.com> --- arch/arm/boot/dts/Makefile | 3 +- arch/arm/boot/dts/imx31-lite.dts | 177 +++++++++++++++++++++++++++++++++++++++ 2 files changed, 179 insertions(+), 1 deletion(-) create mode 100644 arch/arm/boot/dts/imx31-lite.dts