@@ -2328,7 +2328,6 @@ T: git git://git.kernel.org/pub/scm/linux/kernel/git/brgl/linux.git
S: Maintained
F: Documentation/devicetree/bindings/eeprom/at24.txt
F: drivers/misc/eeprom/at24.c
-F: include/linux/platform_data/at24.h
ATA OVER ETHERNET (AOE) DRIVER
M: "Ed L. Cashin" <ed.cashin@acm.org>
@@ -22,10 +22,24 @@
#include <linux/i2c.h>
#include <linux/nvmem-provider.h>
#include <linux/regmap.h>
-#include <linux/platform_data/at24.h>
#include <linux/pm_runtime.h>
#include <linux/gpio/consumer.h>
+/* Address pointer is 16 bit. */
+#define AT24_FLAG_ADDR16 BIT(7)
+/* sysfs-entry will be read-only. */
+#define AT24_FLAG_READONLY BIT(6)
+/* sysfs-entry will be world-readable. */
+#define AT24_FLAG_IRUGO BIT(5)
+/* Take always 8 addresses (24c00). */
+#define AT24_FLAG_TAKE8ADDR BIT(4)
+/* Factory-programmed serial number. */
+#define AT24_FLAG_SERIAL BIT(3)
+/* Factory-programmed mac address. */
+#define AT24_FLAG_MAC BIT(2)
+/* Does not auto-rollover reads to the next slave address. */
+#define AT24_FLAG_NO_RDROL BIT(1)
+
/*
* I2C EEPROMs from most vendors are inexpensive and mostly interchangeable.
* Differences between different vendor product lines (like Atmel AT24C or
@@ -124,10 +138,6 @@ MODULE_PARM_DESC(at24_write_timeout, "Time (in ms) to try writes (default 25)");
usleep_range(1000, 1500), op_time = jiffies)
struct at24_chip_data {
- /*
- * these fields mirror their equivalents in
- * struct at24_platform_data
- */
u32 byte_len;
u8 flags;
};
@@ -467,46 +477,11 @@ static int at24_write(void *priv, unsigned int off, void *val, size_t count)
return 0;
}
-static void at24_properties_to_pdata(struct device *dev,
- struct at24_platform_data *chip)
-{
- int err;
- u32 val;
-
- if (device_property_present(dev, "read-only"))
- chip->flags |= AT24_FLAG_READONLY;
- if (device_property_present(dev, "no-read-rollover"))
- chip->flags |= AT24_FLAG_NO_RDROL;
-
- err = device_property_read_u32(dev, "size", &val);
- if (!err)
- chip->byte_len = val;
-
- err = device_property_read_u32(dev, "pagesize", &val);
- if (!err) {
- chip->page_size = val;
- } else {
- /*
- * This is slow, but we can't know all eeproms, so we better
- * play safe. Specifying custom eeprom-types via platform_data
- * is recommended anyhow.
- */
- chip->page_size = 1;
- }
-}
-
-static int at24_get_pdata(struct device *dev, struct at24_platform_data *pdata)
+static const struct at24_chip_data *at24_get_chip_data(struct device *dev)
{
struct device_node *of_node = dev->of_node;
const struct at24_chip_data *cdata;
const struct i2c_device_id *id;
- struct at24_platform_data *pd;
-
- pd = dev_get_platdata(dev);
- if (pd) {
- memcpy(pdata, pd, sizeof(*pdata));
- return 0;
- }
id = i2c_match_id(at24_ids, to_i2c_client(dev));
@@ -523,13 +498,9 @@ static int at24_get_pdata(struct device *dev, struct at24_platform_data *pdata)
cdata = acpi_device_get_match_data(dev);
if (!cdata)
- return -ENODEV;
+ return ERR_PTR(-ENODEV);
- pdata->byte_len = cdata->byte_len;
- pdata->flags = cdata->flags;
- at24_properties_to_pdata(dev, pdata);
-
- return 0;
+ return cdata;
}
static void at24_remove_dummy_clients(struct at24_data *at24)
@@ -598,8 +569,9 @@ static int at24_probe(struct i2c_client *client)
{
struct regmap_config regmap_config = { };
struct nvmem_config nvmem_config = { };
- struct at24_platform_data pdata = { };
+ const struct at24_chip_data *cdata;
struct device *dev = &client->dev;
+ u32 byte_len, page_size, flags;
bool i2c_fn_i2c, i2c_fn_block;
unsigned int i, num_addresses;
struct at24_data *at24;
@@ -613,35 +585,54 @@ static int at24_probe(struct i2c_client *client)
i2c_fn_block = i2c_check_functionality(client->adapter,
I2C_FUNC_SMBUS_WRITE_I2C_BLOCK);
- err = at24_get_pdata(dev, &pdata);
+ cdata = at24_get_chip_data(dev);
+ if (IS_ERR(cdata))
+ return PTR_ERR(cdata);
+
+ err = device_property_read_u32(dev, "pagesize", &page_size);
+ if (err)
+ /*
+ * This is slow, but we can't know all eeproms, so we better
+ * play safe. Specifying custom eeprom-types via platform_data
+ * is recommended anyhow.
+ */
+ page_size = 1;
+
+ flags = cdata->flags;
+ if (device_property_present(dev, "read-only"))
+ flags |= AT24_FLAG_READONLY;
+ if (device_property_present(dev, "no-read-rollover"))
+ flags |= AT24_FLAG_NO_RDROL;
+
+ err = device_property_read_u32(dev, "size", &byte_len);
if (err)
- return err;
+ byte_len = cdata->byte_len;
if (!i2c_fn_i2c && !i2c_fn_block)
- pdata.page_size = 1;
+ page_size = 1;
- if (!pdata.page_size) {
+ if (!page_size) {
dev_err(dev, "page_size must not be 0!\n");
return -EINVAL;
}
- if (!is_power_of_2(pdata.page_size))
+ if (!is_power_of_2(page_size))
dev_warn(dev, "page_size looks suspicious (no power of 2)!\n");
- if (pdata.flags & AT24_FLAG_TAKE8ADDR)
+ if (flags & AT24_FLAG_TAKE8ADDR)
num_addresses = 8;
else
- num_addresses = DIV_ROUND_UP(pdata.byte_len,
- (pdata.flags & AT24_FLAG_ADDR16) ? 65536 : 256);
+ num_addresses = DIV_ROUND_UP(byte_len,
+ (flags & AT24_FLAG_ADDR16) ? 65536 : 256);
- if ((pdata.flags & AT24_FLAG_SERIAL) && (pdata.flags & AT24_FLAG_MAC)) {
+ if ((flags & AT24_FLAG_SERIAL) && (flags & AT24_FLAG_MAC)) {
dev_err(dev,
"invalid device data - cannot have both AT24_FLAG_SERIAL & AT24_FLAG_MAC.");
return -EINVAL;
}
regmap_config.val_bits = 8;
- regmap_config.reg_bits = (pdata.flags & AT24_FLAG_ADDR16) ? 16 : 8;
+ regmap_config.reg_bits = (flags & AT24_FLAG_ADDR16) ? 16 : 8;
regmap_config.disable_locking = true;
regmap = devm_regmap_init_i2c(client, ®map_config);
@@ -654,11 +645,11 @@ static int at24_probe(struct i2c_client *client)
return -ENOMEM;
mutex_init(&at24->lock);
- at24->byte_len = pdata.byte_len;
- at24->page_size = pdata.page_size;
- at24->flags = pdata.flags;
+ at24->byte_len = byte_len;
+ at24->page_size = page_size;
+ at24->flags = flags;
at24->num_addresses = num_addresses;
- at24->offset_adj = at24_get_offset_adj(pdata.flags, pdata.byte_len);
+ at24->offset_adj = at24_get_offset_adj(flags, byte_len);
at24->client[0].client = client;
at24->client[0].regmap = regmap;
@@ -666,10 +657,10 @@ static int at24_probe(struct i2c_client *client)
if (IS_ERR(at24->wp_gpio))
return PTR_ERR(at24->wp_gpio);
- writable = !(pdata.flags & AT24_FLAG_READONLY);
+ writable = !(flags & AT24_FLAG_READONLY);
if (writable) {
at24->write_max = min_t(unsigned int,
- pdata.page_size, at24_io_limit);
+ page_size, at24_io_limit);
if (!i2c_fn_i2c && at24->write_max > I2C_SMBUS_BLOCK_MAX)
at24->write_max = I2C_SMBUS_BLOCK_MAX;
}
@@ -712,7 +703,7 @@ static int at24_probe(struct i2c_client *client)
nvmem_config.priv = at24;
nvmem_config.stride = 1;
nvmem_config.word_size = 1;
- nvmem_config.size = pdata.byte_len;
+ nvmem_config.size = byte_len;
at24->nvmem = devm_nvmem_register(dev, &nvmem_config);
if (IS_ERR(at24->nvmem)) {
@@ -721,13 +712,9 @@ static int at24_probe(struct i2c_client *client)
}
dev_info(dev, "%u byte %s EEPROM, %s, %u bytes/write\n",
- pdata.byte_len, client->name,
+ byte_len, client->name,
writable ? "writable" : "read-only", at24->write_max);
- /* export data to kernel code */
- if (pdata.setup)
- pdata.setup(at24->nvmem, pdata.context);
-
return 0;
err_clients:
deleted file mode 100644
@@ -1,60 +0,0 @@
-/*
- * at24.h - platform_data for the at24 (generic eeprom) driver
- * (C) Copyright 2008 by Pengutronix
- * (C) Copyright 2012 by Wolfram Sang
- * same license as the driver
- */
-
-#ifndef _LINUX_AT24_H
-#define _LINUX_AT24_H
-
-#include <linux/types.h>
-#include <linux/nvmem-consumer.h>
-#include <linux/bitops.h>
-
-/**
- * struct at24_platform_data - data to set up at24 (generic eeprom) driver
- * @byte_len: size of eeprom in byte
- * @page_size: number of byte which can be written in one go
- * @flags: tunable options, check AT24_FLAG_* defines
- * @setup: an optional callback invoked after eeprom is probed; enables kernel
- code to access eeprom via nvmem, see example
- * @context: optional parameter passed to setup()
- *
- * If you set up a custom eeprom type, please double-check the parameters.
- * Especially page_size needs extra care, as you risk data loss if your value
- * is bigger than what the chip actually supports!
- *
- * An example in pseudo code for a setup() callback:
- *
- * void get_mac_addr(struct nvmem_device *nvmem, void *context)
- * {
- * u8 *mac_addr = ethernet_pdata->mac_addr;
- * off_t offset = context;
- *
- * // Read MAC addr from EEPROM
- * if (nvmem_device_read(nvmem, offset, ETH_ALEN, mac_addr) == ETH_ALEN)
- * pr_info("Read MAC addr from EEPROM: %pM\n", mac_addr);
- * }
- *
- * This function pointer and context can now be set up in at24_platform_data.
- */
-
-struct at24_platform_data {
- u32 byte_len; /* size (sum of all addr) */
- u16 page_size; /* for writes */
- u8 flags;
-#define AT24_FLAG_ADDR16 BIT(7) /* address pointer is 16 bit */
-#define AT24_FLAG_READONLY BIT(6) /* sysfs-entry will be read-only */
-#define AT24_FLAG_IRUGO BIT(5) /* sysfs-entry will be world-readable */
-#define AT24_FLAG_TAKE8ADDR BIT(4) /* take always 8 addresses (24c00) */
-#define AT24_FLAG_SERIAL BIT(3) /* factory-programmed serial number */
-#define AT24_FLAG_MAC BIT(2) /* factory-programmed mac address */
-#define AT24_FLAG_NO_RDROL BIT(1) /* does not auto-rollover reads to */
- /* the next slave address */
-
- void (*setup)(struct nvmem_device *nvmem, void *context);
- void *context;
-};
-
-#endif /* _LINUX_AT24_H */