@@ -49,10 +49,11 @@ config TI_DAVINCI_CPDMA
will be called davinci_cpdma. This is recommended.
config TI_CPSW_PHY_SEL
- bool
+ bool "TI CPSW Phy mode Selection (DEPRECATED)"
+ default n
---help---
This driver supports configuring of the phy mode connected to
- the CPSW.
+ the CPSW. DEPRECATED: use PHY_TI_GMII_SEL.
config TI_CPSW_ALE
tristate "TI CPSW ALE Support"
@@ -64,7 +65,6 @@ config TI_CPSW
depends on ARCH_DAVINCI || ARCH_OMAP2PLUS || COMPILE_TEST
select TI_DAVINCI_CPDMA
select TI_DAVINCI_MDIO
- select TI_CPSW_PHY_SEL
select TI_CPSW_ALE
select MFD_SYSCON
select REGMAP
@@ -21,7 +21,13 @@
((mac)[2] << 16) | ((mac)[3] << 24))
#define mac_lo(mac) (((mac)[4] << 0) | ((mac)[5] << 8))
+#if IS_ENABLED(CONFIG_TI_CPSW_PHY_SEL)
void cpsw_phy_sel(struct device *dev, phy_interface_t phy_mode, int slave);
+#else
+static inline
+void cpsw_phy_sel(struct device *dev, phy_interface_t phy_mode, int slave)
+{}
+#endif
int ti_cm_get_macid(struct device *dev, int slave, u8 *mac_addr);
#endif /* __CPSW_H__ */
Deprecate cpsw-phy-sel driver as it's been replaced with new TI phy-gmii-sel PHY driver. Cc: Kishon Vijay Abraham I <kishon@ti.com> Cc: Tony Lindgren <tony@atomide.com> Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com> --- drivers/net/ethernet/ti/Kconfig | 6 +++--- drivers/net/ethernet/ti/cpsw.h | 6 ++++++ 2 files changed, 9 insertions(+), 3 deletions(-)