diff mbox series

[01/15] dt-bindings: rtc: sun6i-rtc: Rewrite clock outputs as a list

Message ID 20181128093013.24442-2-wens@csie.org (mailing list archive)
State Superseded, archived
Headers show
Series rtc: sun6i: clock rework and pre-H6 SoC support | expand

Commit Message

Chen-Yu Tsai Nov. 28, 2018, 9:29 a.m. UTC
The clock output section for this binding describes the two outputs in
the descriptions for both the #clock-cells and clock-output-names
properties.

Instead of overlapping information that is hard to read, rewrite the
clock outputs as a list of indices and descriptions. The properies
can reference this list instead. This will also make it easier to
add notes or conditions to the clocks, and also for adding new outputs.

Signed-off-by: Chen-Yu Tsai <wens@csie.org>
---
 Documentation/devicetree/bindings/rtc/sun6i-rtc.txt | 10 ++++++----
 1 file changed, 6 insertions(+), 4 deletions(-)

Comments

Maxime Ripard Nov. 28, 2018, 10:17 a.m. UTC | #1
On Wed, Nov 28, 2018 at 05:29:58PM +0800, Chen-Yu Tsai wrote:
> The clock output section for this binding describes the two outputs in
> the descriptions for both the #clock-cells and clock-output-names
> properties.
> 
> Instead of overlapping information that is hard to read, rewrite the
> clock outputs as a list of indices and descriptions. The properies
> can reference this list instead. This will also make it easier to
> add notes or conditions to the clocks, and also for adding new outputs.
> 
> Signed-off-by: Chen-Yu Tsai <wens@csie.org>

Acked-by: Maxime Ripard <maxime.ripard@bootlin.com>

Maxime
diff mbox series

Patch

diff --git a/Documentation/devicetree/bindings/rtc/sun6i-rtc.txt b/Documentation/devicetree/bindings/rtc/sun6i-rtc.txt
index 12c083c1140a..d3e96459fc66 100644
--- a/Documentation/devicetree/bindings/rtc/sun6i-rtc.txt
+++ b/Documentation/devicetree/bindings/rtc/sun6i-rtc.txt
@@ -10,10 +10,12 @@  Required properties:
 
 Required properties for new device trees
 - clocks	: phandle to the 32kHz external oscillator
-- clock-output-names : names of the LOSC and its external output clocks created
-- #clock-cells  : must be equals to 1. The RTC provides two clocks: the
-		  LOSC and its external output, with index 0 and 1
-		  respectively.
+- clock-output-names : names of the two clock outputs. See below.
+- #clock-cells  : must be equal to 1.
+
+The RTC provides the following clocks at the given indices:
+- 0: LOSC
+- 1: LOSC external output, known as X32KFOUT in the datasheet.
 
 Example: