diff mbox series

[10/15] ARM: at91: Implement clocksource selection

Message ID 20190509111048.11151-10-daniel.lezcano@linaro.org (mailing list archive)
State New, archived
Headers show
Series [01/15] clocksource/drivers/sun4i: Add a compatible for suniv | expand

Commit Message

Daniel Lezcano May 9, 2019, 11:10 a.m. UTC 
From: Alexandre Belloni <alexandre.belloni@bootlin.com>

Allow selecting and unselecting the PIT clocksource driver so it doesn't
have to be compiled when unused.

Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
Signed-off-by: Daniel Lezcano <daniel.lezcano@linaro.org>
---
 arch/arm/mach-at91/Kconfig | 23 +++++++++++++++++++++++
 1 file changed, 23 insertions(+)
diff mbox series

Patch

diff --git a/arch/arm/mach-at91/Kconfig b/arch/arm/mach-at91/Kconfig
index 903f23c309df..da1d97a06c53 100644
--- a/arch/arm/mach-at91/Kconfig
+++ b/arch/arm/mach-at91/Kconfig
@@ -107,6 +107,29 @@  config SOC_AT91SAM9
 	    AT91SAM9X35
 	    AT91SAM9XE
 
+comment "Clocksource driver selection"
+
+config ATMEL_CLOCKSOURCE_PIT
+	bool "Periodic Interval Timer (PIT) support"
+	depends on SOC_AT91SAM9 || SOC_SAMA5
+	default SOC_AT91SAM9 || SOC_SAMA5
+	select ATMEL_PIT
+	help
+	  Select this to get a clocksource based on the Atmel Periodic Interval
+	  Timer. It has a relatively low resolution and the TC Block clocksource
+	  should be preferred.
+
+config ATMEL_CLOCKSOURCE_TCB
+	bool "Timer Counter Blocks (TCB) support"
+	default SOC_AT91RM9200 || SOC_AT91SAM9 || SOC_SAMA5
+	select ATMEL_TCB_CLKSRC
+	help
+	  Select this to get a high precision clocksource based on a
+	  TC block with a 5+ MHz base clock rate.
+	  On platforms with 16-bit counters, two timer channels are combined
+	  to make a single 32-bit timer.
+	  It can also be used as a clock event device supporting oneshot mode.
+
 config HAVE_AT91_UTMI
 	bool