diff mbox series

[v2,12/19] phy: mvebu-cp110-comphy: Update comment about powering off all lanes at boot

Message ID 20190627095104.22529-13-miquel.raynal@bootlin.com
State New, archived
Headers show
Series Enhance CP110 COMPHY support | expand

Commit Message

Miquel Raynal June 27, 2019, 9:50 a.m. UTC
Now that all COMPHY modes are supported by the driver, update the
comment stating that mvebu_comphy_power_off() should be called for
each lane. This is still wrong because for compatibility reasons, it
might break users running an old firmware (the driver only uses SMC
calls for SATA, USB and PCIe configuration, there is no code in Linux
to fallback on in these cases.

Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
---
 drivers/phy/marvell/phy-mvebu-cp110-comphy.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)
diff mbox series

Patch

diff --git a/drivers/phy/marvell/phy-mvebu-cp110-comphy.c b/drivers/phy/marvell/phy-mvebu-cp110-comphy.c
index 3fb5517a6d30..36b2056eac99 100644
--- a/drivers/phy/marvell/phy-mvebu-cp110-comphy.c
+++ b/drivers/phy/marvell/phy-mvebu-cp110-comphy.c
@@ -941,9 +941,11 @@  static int mvebu_comphy_probe(struct platform_device *pdev)
 		phy_set_drvdata(phy, lane);
 
 		/*
-		 * Once all modes are supported in this driver we should call
+		 * All modes are supported in this driver so we could call
 		 * mvebu_comphy_power_off(phy) here to avoid relying on the
-		 * bootloader/firmware configuration.
+		 * bootloader/firmware configuration, but for compatibility
+		 * reasons we cannot de-configure the COMPHY without being sure
+		 * that the firmware is up-to-date and fully-featured.
 		 */
 	}