@@ -9,8 +9,6 @@ Required Properties:
- "mediatek,mt7622-sgmiisys", "syscon"
- "mediatek,mt7629-sgmiisys", "syscon"
- #clock-cells: Must be 1
-- mediatek,physpeed: Should be one of "auto", "1000" or "2500" to match up
- the capability of the target PHY.
The SGMIISYS controller uses the common clk binding from
Documentation/devicetree/bindings/clock/clock-bindings.txt
@@ -115,24 +115,34 @@
};
ð {
- pinctrl-names = "default";
- pinctrl-0 = <ð_pins>;
status = "okay";
+ gmac0: mac@0 {
+ compatible = "mediatek,eth-mac";
+ reg = <0>;
+ phy-mode = "2500base-x";
+
+ fixed-link {
+ speed = <2500>;
+ full-duplex;
+ pause;
+ };
+ };
gmac1: mac@1 {
compatible = "mediatek,eth-mac";
reg = <1>;
- phy-handle = <&phy5>;
+ phy-mode = "rgmii";
+
+ fixed-link {
+ speed = <1000>;
+ full-duplex;
+ pause;
+ };
};
- mdio-bus {
+ mdio: mdio-bus {
#address-cells = <1>;
#size-cells = <0>;
-
- phy5: ethernet-phy@5 {
- reg = <5>;
- phy-mode = "sgmii";
- };
};
};
@@ -931,6 +931,5 @@
"syscon";
reg = <0 0x1b128000 0 0x3000>;
#clock-cells = <1>;
- mediatek,physpeed = "2500";
};
};
This patch the removes the recently added mediatek,physpeed property. Use the fixed-link property speed = <2500> to set the phy in 2.5Gbit. See mt7622-bananapi-bpi-r64.dts for a working example. Signed-off-by: René van Dorst <opensource@vdorst.com> -- v2->v3: * no change v1->v2: * SGMII port only support BASE-X at 2.5Gbit. --- .../arm/mediatek/mediatek,sgmiisys.txt | 2 -- .../dts/mediatek/mt7622-bananapi-bpi-r64.dts | 28 +++++++++++++------ arch/arm64/boot/dts/mediatek/mt7622.dtsi | 1 - 3 files changed, 19 insertions(+), 12 deletions(-)