@@ -30,6 +30,11 @@
#define ufs_mtk_device_reset_ctrl(high, res) \
ufs_mtk_smc(UFS_MTK_SIP_DEVICE_RESET, high, res)
+#define ufs_mtk_unipro_powerdown(hba, powerdown) \
+ ufshcd_dme_set(hba, \
+ UIC_ARG_MIB_SEL(VS_UNIPROPOWERDOWNCONTROL, 0), \
+ powerdown)
+
static void ufs_mtk_cfg_unipro_cg(struct ufs_hba *hba, bool enable)
{
u32 tmp;
@@ -290,6 +295,8 @@ static int ufs_mtk_pre_link(struct ufs_hba *hba)
int ret;
u32 tmp;
+ ufs_mtk_unipro_powerdown(hba, 0);
+
/* disable deep stall */
ret = ufshcd_dme_get(hba, UIC_ARG_MIB(VS_SAVEPOWERCONTROL), &tmp);
if (ret)
@@ -390,9 +397,7 @@ static int ufs_mtk_link_set_hpm(struct ufs_hba *hba)
if (err)
return err;
- err = ufshcd_dme_set(hba,
- UIC_ARG_MIB_SEL(VS_UNIPROPOWERDOWNCONTROL, 0),
- 0);
+ err = ufs_mtk_unipro_powerdown(hba, 0);
if (err)
return err;
@@ -413,14 +418,10 @@ static int ufs_mtk_link_set_lpm(struct ufs_hba *hba)
{
int err;
- err = ufshcd_dme_set(hba,
- UIC_ARG_MIB_SEL(VS_UNIPROPOWERDOWNCONTROL, 0),
- 1);
+ err = ufs_mtk_unipro_powerdown(hba, 1);
if (err) {
/* Resume UniPro state for following error recovery */
- ufshcd_dme_set(hba,
- UIC_ARG_MIB_SEL(VS_UNIPROPOWERDOWNCONTROL, 0),
- 0);
+ ufs_mtk_unipro_powerdown(hba, 0);
return err;
}
MediaTek Chipsets can enter proprietary UniPro low-power mode during suspend while link is in hibern8 state. Make sure leaving low-power mode before every link startup to prevent lockup in any possible error recovery path. In the same time, re-factor related funcitons to improve code readability. Signed-off-by: Stanley Chu <stanley.chu@mediatek.com> --- drivers/scsi/ufs/ufs-mediatek.c | 19 ++++++++++--------- 1 file changed, 10 insertions(+), 9 deletions(-)