@@ -213,24 +213,6 @@ static void xenon_set_uhs_signaling(struct sdhci_host *host,
sdhci_writew(host, ctrl_2, SDHCI_HOST_CONTROL2);
}
-static void xenon_set_power(struct sdhci_host *host, unsigned char mode,
- unsigned short vdd)
-{
- struct mmc_host *mmc = host->mmc;
- u8 pwr = host->pwr;
-
- sdhci_set_power_noreg(host, mode, vdd);
-
- if (host->pwr == pwr)
- return;
-
- if (host->pwr == 0)
- vdd = 0;
-
- if (!IS_ERR(mmc->supply.vmmc))
- mmc_regulator_set_ocr(mmc, mmc->supply.vmmc, vdd);
-}
-
static void xenon_voltage_switch(struct sdhci_host *host)
{
/* Wait for 5ms after set 1.8V signal enable bit */
@@ -240,7 +222,6 @@ static void xenon_voltage_switch(struct sdhci_host *host)
static const struct sdhci_ops sdhci_xenon_ops = {
.voltage_switch = xenon_voltage_switch,
.set_clock = sdhci_set_clock,
- .set_power = xenon_set_power,
.set_bus_width = sdhci_set_bus_width,
.reset = xenon_reset,
.set_uhs_signaling = xenon_set_uhs_signaling,
@@ -252,6 +233,7 @@ static const struct sdhci_pltfm_data sdhci_xenon_pdata = {
.quirks = SDHCI_QUIRK_NO_ENDATTR_IN_NOPDESC |
SDHCI_QUIRK_NO_SIMULT_VDD_AND_POWER |
SDHCI_QUIRK_CAP_CLOCK_BASE_BROKEN,
+ .quirks2 = SDHCI_QUIRK2_SET_BUS_VOLTAGE,
};
/*
With the introduction of SDHCI_QUIRK2_SET_BUS_VOLTAGE there is no need to use a custom set_power() implementation as the quirk takes care of configuring the bus voltage register even when powering trough a regulator. Signed-off-by: Nicolas Saenz Julienne <nsaenzjulienne@suse.de> --- drivers/mmc/host/sdhci-xenon.c | 20 +------------------- 1 file changed, 1 insertion(+), 19 deletions(-)