| Message ID | 20200313053224.8172-2-o.rempel@pengutronix.de (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
| Series | properly define some of PHYs | expand |
On Fri, Mar 13, 2020 at 06:32:23AM +0100, Oleksij Rempel wrote: > The Atheros AR8035 PHY can be autodetected but can't use interrupt > support provided on this board. Define MDIO bus and the PHY node to make > it work properly. > > Signed-off-by: Oleksij Rempel <o.rempel@pengutronix.de> Reviewed-by: Andrew Lunn <andrew@lunn.ch> Andrew
diff --git a/arch/arm/boot/dts/imx6dl-riotboard.dts b/arch/arm/boot/dts/imx6dl-riotboard.dts index 829654e1835a..065d3ab0f50a 100644 --- a/arch/arm/boot/dts/imx6dl-riotboard.dts +++ b/arch/arm/boot/dts/imx6dl-riotboard.dts @@ -89,11 +89,25 @@ &fec { pinctrl-names = "default"; pinctrl-0 = <&pinctrl_enet>; phy-mode = "rgmii-id"; - phy-reset-gpios = <&gpio3 31 GPIO_ACTIVE_LOW>; + phy-handle = <&rgmii_phy>; interrupts-extended = <&gpio1 6 IRQ_TYPE_LEVEL_HIGH>, <&intc 0 119 IRQ_TYPE_LEVEL_HIGH>; fsl,err006687-workaround-present; status = "okay"; + + mdio { + #address-cells = <1>; + #size-cells = <0>; + + /* Atheros AR8035 PHY */ + rgmii_phy: ethernet-phy@4 { + reg = <4>; + interrupts-extended = <&gpio1 28 IRQ_TYPE_LEVEL_LOW>; + reset-gpios = <&gpio3 31 GPIO_ACTIVE_LOW>; + reset-assert-us = <10000>; + reset-deassert-us = <1000>; + }; + }; }; &gpio1 {
The Atheros AR8035 PHY can be autodetected but can't use interrupt support provided on this board. Define MDIO bus and the PHY node to make it work properly. Signed-off-by: Oleksij Rempel <o.rempel@pengutronix.de> --- arch/arm/boot/dts/imx6dl-riotboard.dts | 16 +++++++++++++++- 1 file changed, 15 insertions(+), 1 deletion(-)