@@ -6,4 +6,69 @@
/ {
model = "OrangePi Lite2";
compatible = "xunlong,orangepi-lite2", "allwinner,sun50i-h6";
+
+ aliases {
+ serial1 = &uart1; /* BT-UART */
+ };
+
+ wifi_pwrseq: wifi_pwrseq {
+ compatible = "mmc-pwrseq-simple";
+ clocks = <&rtc 1>;
+ clock-names = "ext_clock";
+ reset-gpios = <&r_pio 1 3 GPIO_ACTIVE_LOW>; /* PM3 */
+ post-power-on-delay-ms = <200>;
+ };
+};
+
+&mmc1 {
+ vmmc-supply = <®_cldo2>;
+ vqmmc-supply = <®_bldo3>;
+ mmc-pwrseq = <&wifi_pwrseq>;
+ bus-width = <4>;
+ non-removable;
+ status = "okay";
+
+ brcm: sdio-wifi@1 {
+ reg = <1>;
+ compatible = "brcm,bcm4329-fmac";
+ interrupt-parent = <&r_pio>;
+ interrupts = <1 0 IRQ_TYPE_LEVEL_LOW>; /* PM0 */
+ interrupt-names = "host-wake";
+ };
+};
+
+®_cldo2 {
+ /*
+ * This regulator is connected with CLDO3.
+ * Before the kernel can support synchronized
+ * enable of coupled regulators, keep them
+ * both always on as a ugly hack.
+ */
+ regulator-always-on;
+};
+
+®_cldo3 {
+ /*
+ * This regulator is connected with CLDO2.
+ * See the comments for CLDO2.
+ */
+ regulator-always-on;
+};
+
+/* There's the BT part of the AP6255 connected to that UART */
+&uart1 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>;
+ uart-has-rtscts;
+ status = "okay";
+
+ bluetooth {
+ compatible = "brcm,bcm4345c5";
+ clocks = <&rtc 1>;
+ clock-names = "lpo";
+ device-wakeup-gpios = <&r_pio 1 2 GPIO_ACTIVE_HIGH>; /* PM2 */
+ host-wakeup-gpios = <&r_pio 1 1 GPIO_ACTIVE_HIGH>; /* PM1 */
+ shutdown-gpios = <&r_pio 1 4 GPIO_ACTIVE_HIGH>; /* PM4 */
+ max-speed = <1500000>;
+ };
};