@@ -32,16 +32,14 @@
* to transparently mess with the EL0 bits via CNTKCTL_EL1 access in
* EL2.
*/
-.macro __init_el2_timers mode
-.ifeqs "\mode", "nvhe"
+.macro __init_el2_timers
mrs x0, cnthctl_el2
orr x0, x0, #3 // Enable EL1 physical timers
msr cnthctl_el2, x0
-.endif
msr cntvoff_el2, xzr // Clear virtual offset
.endm
-.macro __init_el2_debug mode
+.macro __init_el2_debug
mrs x1, id_aa64dfr0_el1
sbfx x0, x1, #ID_AA64DFR0_PMUVER_SHIFT, #4
cmp x0, #1
@@ -55,7 +53,6 @@
ubfx x0, x1, #ID_AA64DFR0_PMSVER_SHIFT, #4
cbz x0, .Lskip_spe_\@ // Skip if SPE not present
-.ifeqs "\mode", "nvhe"
mrs_s x0, SYS_PMBIDR_EL1 // If SPE available at EL2,
and x0, x0, #(1 << SYS_PMBIDR_EL1_P_SHIFT)
cbnz x0, .Lskip_spe_el2_\@ // then permit sampling of physical
@@ -66,10 +63,6 @@
mov x0, #(MDCR_EL2_E2PB_MASK << MDCR_EL2_E2PB_SHIFT)
orr x2, x2, x0 // If we don't have VHE, then
// use EL1&0 translation.
-.else
- orr x2, x2, #MDCR_EL2_TPMS // For VHE, use EL2 translation
- // and disable access from EL1
-.endif
.Lskip_spe_\@:
msr mdcr_el2, x2 // Configure debug traps
@@ -145,37 +138,24 @@
/**
* Initialize EL2 registers to sane values. This should be called early on all
- * cores that were booted in EL2.
+ * cores that were booted in EL2. Note that everything gets initialised as
+ * if VHE was not evailable. The kernel context will be upgraded to VHE
+ * if possible later on in the boot process
*
* Regs: x0, x1 and x2 are clobbered.
*/
-.macro init_el2_state mode
-.ifnes "\mode", "vhe"
-.ifnes "\mode", "nvhe"
-.error "Invalid 'mode' argument"
-.endif
-.endif
-
+.macro init_el2_state
__init_el2_sctlr
- __init_el2_timers \mode
- __init_el2_debug \mode
+ __init_el2_timers
+ __init_el2_debug
__init_el2_lor
__init_el2_stage2
__init_el2_gicv3
__init_el2_hstr
-
- /*
- * When VHE is not in use, early init of EL2 needs to be done here.
- * When VHE _is_ in use, EL1 will not be used in the host and
- * requires no configuration, and all non-hyp-specific EL2 setup
- * will be done via the _EL1 system register aliases in __cpu_setup.
- */
-.ifeqs "\mode", "nvhe"
__init_el2_nvhe_idregs
__init_el2_nvhe_cptr
__init_el2_nvhe_sve
__init_el2_nvhe_prepare_eret
-.endif
.endm
#endif /* __ARM_KVM_INIT_H__ */
@@ -501,7 +501,7 @@ SYM_INNER_LABEL(init_el2, SYM_L_LOCAL)
msr hcr_el2, x0
isb
- init_el2_state nvhe
+ init_el2_state
/* Hypervisor stub */
adr_l x0, __hyp_stub_vectors
@@ -189,7 +189,7 @@ SYM_CODE_START_LOCAL(__kvm_hyp_init_cpu)
2: msr SPsel, #1 // We want to use SP_EL{1,2}
/* Initialize EL2 CPU state to sane values. */
- init_el2_state nvhe // Clobbers x0..x2
+ init_el2_state // Clobbers x0..x2
/* Enable MMU, set vectors and stack. */
mov x0, x28