@@ -36,4 +36,7 @@ int trans_pgd_map_page(struct trans_pgd_info *info, pgd_t *trans_pgd,
int trans_pgd_idmap_page(struct trans_pgd_info *info, phys_addr_t *trans_ttbr0,
unsigned long *t0sz, void *page);
+int trans_pgd_copy_el2_vectors(struct trans_pgd_info *info,
+ phys_addr_t *el2_vectors);
+
#endif /* _ASM_TRANS_TABLE_H */
@@ -67,6 +67,9 @@
*/
extern u32 __boot_cpu_mode[2];
+extern char __hyp_stub_vectors[];
+#define ARM64_VECTOR_TABLE_LEN SZ_2K
+
void __hyp_set_vectors(phys_addr_t phys_vector_base);
void __hyp_reset_vectors(void);
@@ -48,12 +48,6 @@
*/
extern int in_suspend;
-/* temporary el2 vectors in the __hibernate_exit_text section. */
-extern char hibernate_el2_vectors[];
-
-/* hyp-stub vectors, used to restore el2 during resume from hibernate. */
-extern char __hyp_stub_vectors[];
-
/*
* The logical cpu number we should resume on, initialised to a non-cpu
* number.
@@ -428,6 +422,7 @@ int swsusp_arch_resume(void)
void *zero_page;
size_t exit_size;
pgd_t *tmp_pg_dir;
+ phys_addr_t el2_vectors;
void __noreturn (*hibernate_exit)(phys_addr_t, phys_addr_t, void *,
void *, phys_addr_t, phys_addr_t);
struct trans_pgd_info trans_info = {
@@ -455,6 +450,14 @@ int swsusp_arch_resume(void)
return -ENOMEM;
}
+ if (is_hyp_callable()) {
+ rc = trans_pgd_copy_el2_vectors(&trans_info, &el2_vectors);
+ if (rc) {
+ pr_err("Failed to setup el2 vectors\n");
+ return rc;
+ }
+ }
+
exit_size = __hibernate_exit_text_end - __hibernate_exit_text_start;
/*
* Copy swsusp_arch_suspend_exit() to a safe page. This will generate
@@ -467,25 +470,14 @@ int swsusp_arch_resume(void)
return rc;
}
- /*
- * The hibernate exit text contains a set of el2 vectors, that will
- * be executed at el2 with the mmu off in order to reload hyp-stub.
- */
- __flush_dcache_area(hibernate_exit, exit_size);
-
/*
* KASLR will cause the el2 vectors to be in a different location in
* the resumed kernel. Load hibernate's temporary copy into el2.
*
* We can skip this step if we booted at EL1, or are running with VHE.
*/
- if (is_hyp_callable()) {
- phys_addr_t el2_vectors = (phys_addr_t)hibernate_exit;
- el2_vectors += hibernate_el2_vectors -
- __hibernate_exit_text_start; /* offset */
-
+ if (is_hyp_callable())
__hyp_set_vectors(el2_vectors);
- }
hibernate_exit(virt_to_phys(tmp_pg_dir), resume_hdr.ttbr1_el1,
resume_hdr.reenter_kernel, restore_pblist,
@@ -322,3 +322,23 @@ int trans_pgd_idmap_page(struct trans_pgd_info *info, phys_addr_t *trans_ttbr0,
return 0;
}
+
+/*
+ * Create a copy of the vector table so we can call HVC_SET_VECTORS or
+ * HVC_SOFT_RESTART from contexts where the table may be overwritten.
+ */
+int trans_pgd_copy_el2_vectors(struct trans_pgd_info *info,
+ phys_addr_t *el2_vectors)
+{
+ void *hyp_stub = trans_alloc(info);
+
+ if (!hyp_stub)
+ return -ENOMEM;
+ *el2_vectors = virt_to_phys(hyp_stub);
+ memcpy(hyp_stub, &__hyp_stub_vectors, ARM64_VECTOR_TABLE_LEN);
+ __flush_icache_range((unsigned long)hyp_stub,
+ (unsigned long)hyp_stub + ARM64_VECTOR_TABLE_LEN);
+ __flush_dcache_area(hyp_stub, ARM64_VECTOR_TABLE_LEN);
+
+ return 0;
+}
Users of trans_pgd may also need a copy of vector table because it is also may be overwritten if a linear map can be overwritten. Move setup of EL2 vectors from hibernate to trans_pgd, so it can be later shared with kexec as well. Suggested-by: James Morse <james.morse@arm.com> Signed-off-by: Pavel Tatashin <pasha.tatashin@soleen.com> --- arch/arm64/include/asm/trans_pgd.h | 3 +++ arch/arm64/include/asm/virt.h | 3 +++ arch/arm64/kernel/hibernate.c | 28 ++++++++++------------------ arch/arm64/mm/trans_pgd.c | 20 ++++++++++++++++++++ 4 files changed, 36 insertions(+), 18 deletions(-)