diff mbox series

[net-next,6/6] stmmac: intel: add pcs-xpcs for Intel mGbE controller

Message ID 20210315052711.16728-7-boon.leong.ong@intel.com (mailing list archive)
State New, archived
Headers show
Series net: pcs, stmmac: add C37 AN SGMII support | expand

Commit Message

Ong Boon Leong March 15, 2021, 5:27 a.m. UTC
Intel mGbE controller such as those in EHL & TGL uses pcs-xpcs driver for
SGMII interface. To ensure mdio bus scanning does not assign phy_device
to MDIO-addressable entities like intel serdes and pcs-xpcs, we set up
to phy_mask to skip them.

Signed-off-by: Ong Boon Leong <boon.leong.ong@intel.com>
---
 drivers/net/ethernet/stmicro/stmmac/dwmac-intel.c | 15 ++++++++++++++-
 1 file changed, 14 insertions(+), 1 deletion(-)
diff mbox series

Patch

diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-intel.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-intel.c
index 0b64f7710d17..c49646773871 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-intel.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-intel.c
@@ -9,6 +9,9 @@ 
 #include "dwmac4.h"
 #include "stmmac.h"
 
+#define INTEL_MGBE_ADHOC_ADDR	0x15
+#define INTEL_MGBE_XPCS_ADDR	0x16
+
 struct intel_priv_data {
 	int mdio_adhoc_addr;	/* mdio address for serdes & etc */
 };
@@ -333,6 +336,16 @@  static int intel_mgbe_common_data(struct pci_dev *pdev,
 	/* Use the last Rx queue */
 	plat->vlan_fail_q = plat->rx_queues_to_use - 1;
 
+	/* Intel mgbe SGMII interface uses pcs-xcps */
+	if (plat->phy_interface == PHY_INTERFACE_MODE_SGMII) {
+		plat->mdio_bus_data->has_xpcs = true;
+		plat->mdio_bus_data->xpcs_an_inband = true;
+	}
+
+	/* Ensure mdio bus scan skips intel serdes and pcs-xpcs */
+	plat->mdio_bus_data->phy_mask = 1 << INTEL_MGBE_ADHOC_ADDR;
+	plat->mdio_bus_data->phy_mask |= 1 << INTEL_MGBE_XPCS_ADDR;
+
 	return 0;
 }
 
@@ -664,7 +677,7 @@  static int intel_eth_pci_probe(struct pci_dev *pdev,
 	pci_set_master(pdev);
 
 	plat->bsp_priv = intel_priv;
-	intel_priv->mdio_adhoc_addr = 0x15;
+	intel_priv->mdio_adhoc_addr = INTEL_MGBE_ADHOC_ADDR;
 
 	ret = info->setup(pdev, plat);
 	if (ret)